LED WORLD QS-701C-1W Manuel utilisateur

Marque: LED WORLD

Modèle: QS-701C-1W

Taper: Manuel utilisateur

IMPORTANT INSTRUCTIONS

1-800-387-4081

ledworldlighting.com ledworld.ca |

Copyright © 2022 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).

LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.1 - 09/28/22

LED RECESSED WALL LIGHT

WARNING: Always connect the LED light to the power supply rst and then connect the power supply to the mains. Failure to do so may cause damage

to the existing diode.

ŸInsert the light into the hole; ction t light will lock in place.

ŸConnect the light’s low voltage wiring into the class 2 LED power supply. (# # - sold separately).MD-012-060VTDHV2 MD-012-030VTDHV2

ŸTurn power off prior to installation.

ŸBore a hole Ø1.77” (45mm) minimum recess depth required 1.45” (37mm).

Installation instructions:

ŸMust be installed by a qualied licenced electrician.

ŸRoute the low voltage wiring through the hole.

Instructions d'installation:

ŸPour de meilleurs résultats, ayez recours aux services d'un électricien agréé qualié pour une installation professionnelle de votre luminaire.

ŸBranchez le câbe de basse tension du lumière dans la l'alimentation LED classe 2. (# # - vendu séparément).MD-012-060VTDHV2 MD-012-030VTDHV2

MISE EN GARDE: Il faut toujours brancher le luminaire DEL à source d'alimentation en premier et ensuite brancher l'alimentation à la source principale

d'alimentation électrique. Le défaut de le faire pourrait causer des dommages à la diode en place.

ŸInsérez le lumière dans le trou an de xer solidement le luminaire en place.

ŸPercez un trou de Ø1.77" (45mm) profondeur de l'embrasure minimum requise de 1.45" (37mm).

ŸPassez le câble de basse tension à travers le trou.

ŸFermez l'alimentation électrique avant de procéder à l'installation.

INSTRUCTIONS IMPORTANTES

THREE YEAR LIMITED LIGHTING WARRANTY

LED WORLD INC. warranties this product for three year (some exceptions may apply) from the date of shipping unless otherwise noted in writing. This warranty is expressly in lieu of all other warranties expressed or

implied. Under this Limited Warranty, the obligation of the company is limited to replacing on a prorated basis, at its option, any component found to be defective. This Limited Warranty does not apply to damage

caused by buyer or alteration to the product or incorrect power supply. Factory warrantees are covered by the original manufacturer and claims must be submitted to them.

LED World Inc. And its providers will never be liable to you or any other person for any indirect, incidental, consequential, special, punitive or exemplary loss or damage arising from, connected with, the purchase

of products, including but not limited to loss of data, business, markets, cost of labour, savings, income, profits, use, production, reputation or goodwill, anticipated or otherwise, or economic loss, under any theory

of liability (whether in contract, tort, strict liability or any other theory or law or equity), regardless of any negligence or other fault or wrongdoing (including without limitation gross negligence and fundamental

breach) by led world inc. Or any person for whom led world inc. Is responsible, and even if led world inc. Has been advised of the possibility of such loss or damage being incurred.

If a product is defective, we will replace the product with similar or identical product or at our option a credit towards a future purchase. To make a claim under this warranty, obtain a return authorization number.

Model : QS-701C-1W

For Recessed Stair and Wall Lighting

ŸTurn off the power at breaker

RECESSED MOUNTING:

ŸConnect light to the Class 2 driver,

see g 2.

ŸTurn on the power.

ŸInsert the recessed puck light into

the cut hole, see g 1a.

ŸDrill a Ø45mm hole through

cabinet or shelf, see g 1.a

Recessed Mounting