Blackview A53PRO Manuel utilisateur

Marque: Blackview

Modèle: A53PRO

Taper: Manuel utilisateur

15.19 Labeling requirements.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and(2) this device must accept

any interference received, including interference that may cause undesired operation.

15.21 Information to user.

Any Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

15.105 Information to the user.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-Consult the dealer or an experienced radio/TV technician for help.

Absorption Rate (SAR) information:

This ^ŵĂƌƚ ƉŚŽŶĞ meets the government's requirements for exposure to radio waves. The

guidelines are based on standards that were developed by independent scientific organizations

through periodic and thorough evaluation of scientific studies. The standards include a

substantial safety margin designed to assure the safety of all persons regardless of age or health.

FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged

over one gram of tissue. This device was tested for typical body-worn operations with the back of

the handset kept 1.0cm from the body. To maintain compliance with FCC RF exposure

requirements, use accessories that maintain a 1.0cm separation distance between the user's

body and the back of the handset. The use of belt clips, holsters and similar accessories should

not contain metallic components in its assembly. The use of accessories that do not satisfy these

requirements may not comply with FCC RF exposure

requirements, and should be avoided.

Body-worn Operation

This device was tested for typical body-worn operations. To comply with RF exposure

requirements, a minimum separation distance of 1.0 cm must be maintained between the user’s

body and the handset,including the antenna. Third-party belt-clips, holsters, and similar

accessories used by this device should not contain any metallic components. Body-worn

accessories that do not meet these requirements may notcomply with RF exposure requirements

and should be avoided. Use only the supplied or an approved antenna.

1
2
3
4
5
6

Blackview A53PRO Manuel utilisateur

Marque: Blackview

Modèle: A53PRO

Taper: Manuel utilisateur

Télécharger le PDF

dans d''autres langues

English: Blackview A53PRO User manual

Documents connexes

Autres documents