Dorel Home 4292129 Assembly Manual

Date of Purchase

Upholstered Bed with Storage

Lot Number (TAKEN FROM CARTON)

Thank you for purchasing from DHP!

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY

INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.

1

VN. - 2022/02/09

Full

Weight Limit:

Bed: 450 lb / 204 kg

Drawer 40 lb / 18 kg

B34429212901 - 36213705

Questions, concerns, missing parts?

CONTACT OUR CUSTOMER SERVICE DEPARTMENT

BEFORE RETURNING PRODUCT TO THE RETAILER.

If parts are missing or damaged, we will gladly ship your

replacement parts free of charge.

Visit www.dhpfurniture.com/eng/replacement-parts

or call Toll-Free 1-800-267-1739.

You can also chat with us at www.dhpfurniture.com

4291029 (Black Faux Leather)

4292129 (White Faux Leather)

2

1-800-267-1739

Monday to Friday

Saturday

Sunday

DHP Consumer Services

12345 Albert Hudon, Suite 100,

Montreal, Quebec H1G 3L1

cs@dhpfurniture.com

Read Before Beginning Assembly

●Work in a spacious area and near where the unit will be used, preferably on a

carpet, or use a piece of the cardboard packaging to protect your floor and product.

●Make sure all parts are included. Most parts are labeled or stamped on the raw

edge.

●Read each step carefully. It is very important that each step of the instructions is

performed in the correct order. If these steps are not followed in sequence,

assembly difficulties will occur.

●This product may contain small components. Please ensure that they are kept

away from small children.

●This product is designed for home use and is not intended for commercial use.

Contact Us!

For help with assembly, identifying parts, product information or to order parts,

please contact us:

Limited 1 year Warranty

DHP warrants this product to be free from defects in material and workmanship

and agrees to remedy any such defect. This warranty covers one year from the

date of original purchase from authorized retailers. This is solely limited to the

repair or replacement of defective parts and assembly labor is not included.

This warranty does not apply to any product which has been improperly

assembled, subjected to misuse or abuse or which has been altered or repaired in

any way.The warranty does not cover wearing, tearing, fading or splitting of the

fabric (where applicable). Liability for consequential damages is excluded to the

extent exclusion is permitted by law. This warranty gives you specific legal rights

and you may also have other rights which vary from state to state or province to

province.

To obtain warranty service, purchaser must present original bill of sale.

Components repaired or replaced are warranted through the remainder of the

original warranty period only. The defective components will be repaired or

replaced without charge, subject to the terms and conditions described above.

Visit www.dhpfurniture.com to view the limited warranty valid in the U.S. and

Canada.

9 am to 9 pm (Eastern Time)

10 am to 6:30 pm (Eastern Time)

11 am to 7 pm (Eastern Time)

Do NOT use

powertools

Chat

with us! www.dhpfurniture.com

1.5 hour

This product is shipped in 1 carton

PARTS

3

PARTS LIST

HEADBOARD

X 1 PC

BACK PANEL

X 1 PC

FOTTBOARD

X 1 PC

SIDE RAIL

X 2 PCS

SIDE RAIL

X 2 PCS

CENTER RAIL

X 2 PCS

GUIDE

X 2 PCS

SUPPORT RAIL

X 1 PC

WOODEN SLATS

X 24 PCS

BRACKET

X 2 PCS

4

PART NUMBERS

PART LABELS

4291029

(Black Faux Leather)

4292129

(White Faux Leather)

A

T1017390

T1019870

A1

T1019290

B

T1017400

T1019880

E

T1019100

F

T1019110

I

T1019120

J

T1019310

K

T1019320

P

T1013760

G

T1019150

Each part has a unique part number.

Please reference the appropriate part

number when contacting customer

service for replacement parts.

Before throwing any packaging, please

verify all contents and make sure you

have received all the parts listed above!

AA1 EF

KPG

I J

B

PARTS LIST

SINGLE SLAT CAP

X 24 PCS

DOUBLE SLAT CAP

X 12 PCS

FRONT PANEL

X 4 PCS

DRAWER BOTTOM PANEL

X 4 PCS

DRAWER BACK PANEL

X 4 PCS

DRAWER SIDE PANEL

X 4 PCS

DRAWER SIDE PANEL

X 4 PCS

CASTER

X 20 PCS

Each part has a unique part number.

Please reference the appropriate part

number when contacting customer

service for replacement parts.

Before throwing any packaging, please

verify all contents and make sure you

have received all the parts listed above!

5

PART NUMBERS

PART LABELS

4291029

(Black Faux Leather)

4292129

(White Faux Leather)

X

T1013930

Y

T1013940

C

T1019180

T1019270

L

T1019190

M

T1019200

N

T1019210

S

T1019220

Q

T1019230

X Y C L M

N S Q

6

Please do not completely tighten all the hardware,

until the entire assembly is complete, unless

otherwise indicated in the step-by-step instructions.

The screw(s), bolt(s) to be used at each step are shown

in actual size in the lower right corner of the page.

Hardware Pack

4291029 (Black Faux Leather)

4292129 (White Faux Leather) HP # : T4155429-00

HARDWARE LIST

1

BOLT

X 12 PCS

BOLT

X 4 PCS

BOLT

X 12 PCS

BOLT

X 8 PCS

BOLT

X 2 PCS

BOLT

X 8 PCS

BOLT

X 24 PCS

BOLT

X 56 PCS

1/4’’

WASHER

X 4 PCS

ALLEN KEY

X 1 PC

1/4’’ x 3/4’’ 1/4’’ x 3/4’’ 1/4’’ x 1 3/16’’ 1/4’’ x 1 9/16’’ 1/4’’ x 1 9/16’’

6 7 8 9

5

432

1

10

3/16’’ x 3/8’’ 3/16’’ x 7/8’’ 3/16 x 3/4’’ 4 mm

Step 1

Stịck back panel A1 to the back of

Headboard A with Velcro as illustrated.

7

Step 2

Attach Guide J X 2 to Headboard A and

Footboard B with bolts ❸.

8

X 6

3

Step 3

Attach brackets G X 2 to support rail K

with bolts ❸.

Fully tighten all the bolts in this step.

9

X 6

3

Step 4

Attach side rails E and F to bracket G

with bolts ❶ as shown.

Don’t completely tighten the bolts until

STEP 6 is completed.

10

X 8

1

Step 5

Attach side rails E and F to Headboard

A and Footboard B with bolts

11

4

X 8

4

Step 6

6.1 Attach I X 2 to Headboard A and

Footboard B with bolts ❶

6.2 Attach I X 2 to support rail K with

bolts . Then, properly tighten all the

bolts.

12

Slat holes on part I

must face upwards.

5

X 2 X 4

1

5

Step 7

7.1 Insert Slats P into single slat cap X,

7.2 Press X into side rails E & F, repeat

the same procedure for the opposite

side.

7.3 Insert ends of both slats P into

double slat cap Y, then press Y into I as

illustrated.

Repeat the same procedures going

backwards for every row of slats.

13

Step 8

Attach drawer back panel M to drawer

side panels S and N with bolts .

Don’t completely tighten the bolts until

STEP 10 is completed.

14

7

Make sure that these holes are all located on

the top side before assembling.

For better performance, please orient the

plastic sheet towards inside of the drawer.

X 4

X 16

7

Step 9

9.1 Attach caster Q to drawer bottom

panel L with bolts .

9.2 Attach drawer bottom panel L to

drawer back panel M with bolt .

9.3 Attach caster Q X 4 and drawer

bottom panel L to drawer side panels S

and N with bolts .

15

7

6

8

6

X 8

7

X 32

8

X 8

Step 10

16

Attach the sub-assembly L/S/N/M from

previous step to front panel C with bolts .

Then, properly tighten all the bolts.

8

X 24

8

Step 11

17

Attach bolts and washers as shown.

2 9

9

X 4

2

Step 12

18

Align Drawers with the bed frame and push

them into the bed.

Lock drawers by slightly lifting drawer and

inserting the Pin into the Slot.

CAUTION: This unit is intended for use only with the products and/or maximum

weights indicated. Use with other products and/or products heavier than the

maximum weights indicated may result in instability or cause possible injury.

Helpful Hints

Weight Limit:

Bed: 450 lb / 204 kg

Drawer: 40 lb / 18 kg

That's it ! You've finished assembling your Upholstered Bed!

Move your new furniture carefully, with two

people lifting and carrying the unit to its new

location.

Your furniture can be disassembled and

reassembled to move.

Clean the product with a soft damp cloth. DO

NOT use harsh chemicals or abrasive cleaners.

Check bolts and nuts periodically and tighten if

necessary.

Some parts have been pre-assembled for this

item. They are illustrated on this page and

available for replacement.

19

WARNING

For safety reasons and to prevent injuries:

This bed is not intended for use by children under 4

years old.

Prohibit jumping and horseplay on this bed.

Only use a mattress which is 74" - 75" long and

53" - 54" wide.

Do not stand on drawer.

Do not use risers under this bed.

ESTE INSTRUCTIVO CONTIENE INFORMACION IMPORTANTE DE

SEGURIDAD. POR FAVOR LEA Y GUARDE PARA SU REFERENCIA FUTURA.

Lea antes de comenzar a ensamblar

Llame a nuestro nûmero gratuito si necesita asistencia.

Trabaje en un area espaciosa y cerca de donde su producto sera utilizado,

preferiblemente sobre una alfombra o utilice el cartôn del empaque para

proteger su piso y su producto.

El número de personas recomendadas para el montaje de este

¡Gracias por tu compra DHP!

Información sobre la garantía

Dorel garantiza que este producto está libre de defectos de material y mano de

obra y se compromete a remediar cualquier defecto de este tipo. Esta garantía

cubre 1 año a partir de la fecha de compra original. Esta garantía es válida

solamente con presentación de una prueba de compra. Esto se limita a la

reparación o reemplazo de componentes defectuosos del mueble y no se incluye

ningún trabajo de ensamblaje.

Esta garantía no se aplica a ningún producto que haya sido mal ensamblado,

sujeto a mal uso o abuso, o que haya sido alterado o reparado de cualquier

manera. Cualquier uso, rotura o pérdida de color de la tela no están incluidos en

esta garantía (donde corresponda). Esta garantía le da derechos legales

específicas y usted puede también tener otros derechos que varían de estado a

estado o de provincia a provincia.

Para obtener el servicio de garantía, debe presentar la factura original de su

compra. Los componentes reparados o reemplazados están garantizados durante

el periodo original de la garantía. Las partes defectuosas serán reparadas o

reemplazadas sin cargo extra y sujetas a los términos y condiciones descritos

anteriormente. Visite www.dhpfurniture.com para ver la garantía limitada válida

en E.U. y Canadá.

Precauciones

•Este producto está diseñado para uso doméstico y no para uso comercial.

•ADVERTENCIA PARA NIÑOS PEQUEÑOS - Este producto contiene

componentes pequeños. Por favor asegúrese de que las piezas estén fuera

del alcance de los niños.

•No utilice herramientas eléctricas para ensamblar su mueble. Este tipo de

herramientas pueden rasgar o dañar las partes.

Chatea con nosotros : www.dhpfurniture.com

cs@dhpfurniture.com

1-800-267-1739

Lunes - Viernes / 9 am - 9 pm (hora del este)

Sábado / 10 am - 6:30 pm (hora del este)

Domingo / 11 am - 7 pm (hora del este)

• DHP Servicios al Cliente

12345 Albert Hudon, Suite 100, Montreal, Quebec, Canada, H1G 3L1

•

Cama tapizada

Matrimonial

producto es: 2 (sin embargo es recomendable contar con ayuda adicional).

Tiempo estimado de ensamble es 1.5 horas.

Asegûrese de que todas las partes estan incluidas. La mayorfa de las partes

estan etiquetadas o selladas en los bordes.

Lea cada paso cuidadosamente. Es muy importante que cada paso de las

instrucciones sea realizado en el orden correcto. Si estos pasos no se siguen

en secuencia, pueden ocurrir dificultades durante el ensamblado.

¡Contáctenos!

Para solicitar ayuda con el ensamblaje, identificaciôn de partes, informaciôn del

producto o simplemente ordenar otras partes, dirfjase a:

Preguntas, inquietudes, partes que faltan? CONTACTE

NUESTRO DEPARTAMENTO DE SERVICIO AL CLIENTE

ANTES DE DEVOLVER EL PRODUCTO A LA TIENDA.

Si le faltan piezas o las que se incluyen están dañadas, con mucho

gusto le enviaremos sus piezas de reemplazo sin cargo extra.

Visite www.dhpfurniture.com/spa/replacement-parts , llame gratis al

1-800-267-1739 o chatea con nosotros al www.dhpfurniture.com

ES

Fecha de compra Número de lote

4291029 (Imitación de cuero Negro)

4292129 (Imitación de cuero Blanco)

La page charge ...

Dorel Home 4292129 Assembly Manual

Ce manuel convient également à

Dorel Home 4292129 Assembly Manual

dans d''autres langues

Documents connexes

Autres documents