CORDLESS LAWN MOWER EN
13
4. BATTERY STATUS LED’S (See Fig. I)
NOTE: The Status LED’s will indicate the battery
condition when the button on the battery is
pressed.
The LED’s constantly senses and displays the battery
condition as follows:
Press the button “POWERTEST”, the light button is
illuminated.
When the three green lights are illuminated, the
battery is in a highly charged condition.
When two lights (
) are illuminated, the battery is
in a moderately charged condition.
When only one green light ( ) is illuminated, the
battery charge is depleted.
%HIRUHXVLQJ\RXUQHZPRZHUIRUWKHÀUVWWLPHLWLV
recommended that the unit be charged overnight to
ensure that the battery is fully charged.
IMPORTANT: When only one light is illuminated,
your battery is overly discharged, even though
the mower may still be capable of cutting grass.
Continuing to operate your lawnmower with the
battery in this discharged condition may reduce
the life and performance of your battery.
6. ADJUSTING THE CUTTING HEIGHT (See Fig. J)
WARNING: Before adjusting the mower height,
wait for the mower to completely stop. Mower
blades continue to rotate after the machine is
switched off and a rotating blade can cause injury.
Wait until all machine components have completely
stopped before touching them and remove safety key
(6).
The lawnmower can be set to 3 cutting heights with
PP
Turn the mower onto its side. Grip one wheel and pull
bar out of the groove and reposition it to the required
KHLJKW)RUÀUVWXVHVHWWKHFXWWLQJKHLJKWDWPP
ALL other wheels should be positioned at the same
height.
7. MOWING TIPS
NOTE: Always inspect area where mower is to be
used and remove all stones, sticks, wire, metal and
other debris which might be thrown by the rotating
blade.
1. Mow across the face of slopes, never up-and-
down. Exercise extreme caution when changing
direction on slopes. Do not mow excessively steep
slopes. Always maintain good footing.
2. Release switch lever to turn mower “OFF” when
crossing any graveled area (stones can be thrown
by the blade).
3. Set mower at highest cutting height when mowing
in rough ground or in tall weeds. Removing too
much grass at one time can cause circuit breaker
to trip, which stops mower.
4. If a grass bag is used during the fast growing
season, the grass may tend to clog up at the
discharge opening. Release switch lever to turn
mower “OFF” and remove the safety key. Remove
the grass bag and shake the grass down to the
back end of the bag. Also clean out any grass or
debris which may be packed around the discharge
opening. Replace the grass bag.
5. If mower should start to vibrate abnormally,
release switch lever to turn mower “OFF” and
remove safety key. Check immediately for cause.
Vibration is a warning of trouble. Do not operate
mower until a service check has been made.
6. ALWAYS RELEASE SWITCH LEVER TO TURN MOWER
“OFF” AND REMOVE SAFETY KEY WHEN LEAVING IT
UNATTENDED EVEN FOR A SHORT PERIOD OF TIME.
MAINTENANCE
WARNING: Stop the mower and remove the
safety key before removing the grass bag.
NOTE: To ensure long and reliable service, perform the
following maintenance procedures regularly. Check
for obvious defects such as a loose, dislodged or a
GDPDJHGEODGHORRVHÀWWLQJVDQGZRUQRUGDPDJHG
components. Check that the covers and guards are
all undamaged and are correctly attached to mower.
Carry out any necessary maintenance or repairs
before operating mower. If the mower should happen
to fail despite regular maintenance, please call our
customer helpline for advice.
BLADE SHARPENING
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE. A DULL BLADE DOES NOT CUT
GRASS CLEANLY.
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING BLADE.
ENSURE THAT SAFETY KEY IS REMOVED.
Sharpening the blade twice during a mowing season
LVXVXDOO\VXIÀFLHQWXQGHUQRUPDOFLUFXPVWDQFHV
Sand causes the blade to dull quickly. If your lawn has
sandy soil, more frequent sharpening may be required.
REPLACE BENT OR DAMAGED BLADE IMMEDIATELY.