Specifications
Design and specifications are subject to change without notice.
Physical Specifications
Product: AB1 battery
Dimensions: 82.5 x 63.5 x 22 mm (3.25 x 2.65 x 0.9 in)
Weight: 132 g (4.64 oz)
Capacity and Output Specifications
Maximum output: 8.4 VDC
Mean output: 7.4 VDC
Capacity: 2200 mAh
Temperature Specifications
Operating temperature:
0°C to 50°C (32°F to 122°F)
Storage temperature:
-20°C to 60°C (-4°F to 140°F)
Humidity Specifications
Operating humidity: 10% to 90% non-condensing
Storage humidity: 0% to 95% non-condensing
6001 36th Avenue West
Everett, WA 98203
U.S.A.
www.intermec.com
© 2003 Intermec Technologies Corp.
All Rights Reserved
AB1 Battery Instructions
*073431-001*
P/N 073431-001
AB1 Battery Instructions
The AB1 battery is a 2200 mAh lithium-ion battery designed for use
in the CK30 Handheld Computers. Before using the battery, please
read these instructions thoroughly and keep them for future
reference.
Replacing the Battery
1 Turn off the CK30.
2 Pull down on the battery latch.
3 Pull out the discharged battery.
AB1
battery
Battery
latch
4 Insert the tabs on the bottom of the charged battery into the
CK30, and then snap the battery into place.
If you fail to replace the battery immediately, you may
lose important data or applications.
Attention: Si la batterie n’est pas remplacée
immédiatement, des données ou applications
importantes risquent d’être perdues.
For best performance, keep a charged battery in the CK30.
Charging the Battery
Use the following table to understand the charging methods and
times for the AB1 battery. The charging times indicate the maximum
amount of time to charge a fully discharged battery. It may take less
time to charge the battery depending on the state of the battery
charge.
Charging Methods and Times
Method Time
AC1 4-Slot Battery Charger 5 hours
AC2 4-Bay Charging Dock 5 hours
AD1 1-Bay Communications Dock 3 hours
AD2 4-Bay Communications Dock 5 hours
Note: The charging times are at 21°C (69.8°F). Charging
time will vary depending on temperature.
• You must fully charge your battery prior to using it in a CK30.
• You can charge a battery after partial discharge without affecting
the original battery capacity.
Use only the methods described in this instruction sheet
to recharge the AB1 battery. Recharging this battery with
any other charger could result in damage to the battery.
Attention: Utilisez seulement les méthodes décrites dans
cette feuille d’instructions pour recharger le bloc-batterie
AB1. Ne pas recharger cette batterie avec un autre type
de chargeur car cela risque d’endommager la batterie.
Important Recommendations
• Charge the battery immediately before use or within a couple of
days of use.
• Do not short circuit the battery and keep it away from metallic
items.
• Do not disassemble, open, or modify the battery.
• Do not expose the battery to excessive heat or fire.
• Do not store the battery at temperatures above 60°C (140°F),
such as inside a car on a hot day or in direct sunlight, as this may
damage the battery.
• Do not immerse the battery in water or get the battery wet.
• Do not solder directly to the battery contacts.
• Use the AB1 battery only with a CK30. Use of this battery in
other applications could result in damage to the device or battery.
• For maximum battery efficiency, the temperature range for
charging and storing batteries is 0°C to 45°C (32°F to 113°F).
• Keep the battery contacts clean and free of dust and dirt.
• Do not recharge batteries in locations that are extremely hot or
cold, dusty or dirty, very humid, or subject to vibration.
Disposing of the Battery
Li-ion
Li-ion
When the battery reaches the end of its useful life, the spent
battery should be disposed of by a qualified recycler or
hazardous materials handler. If you are unsure of how to
properly dispose of this battery, contact your local Intermec
office for disposal information.
• Discarded batteries may create a safety hazard. Before disposal,
cover the battery contact terminals with electrical insulating tape.
• Keep away from children.
• Do not disassemble or dispose of in fire.
• Do not mix these batteries with the solid waste stream. (Required
in European countries.)
-
1
-
2
Intermec AC1 Mode d'emploi
- Taper
- Mode d'emploi
dans d''autres langues
- English: Intermec AC1 Operating instructions
Documents connexes
Autres documents
-
Perfectpro AUDISSE Getting Started
-
Olympus ET-CK30 Manuel utilisateur
-
dji RoboMaster Guide de démarrage rapide
-
Tamiya Reefer Semi-Trailer Le manuel du propriétaire
-
Matrix MG-A82 Le manuel du propriétaire
-
Siemens Gigaset CX203 isdn Le manuel du propriétaire
-