Haier HF-255SAA Le manuel du propriétaire

FUNCTION ECO 2: When thetemperature issetwithinarangefrom -23 C to -26 C,afterthe

freezerhas run for 56 hours,it willautomatically besetat -22 C,inorder tosaveenergy and to

effectively preserve food.Ordinary food can be effectively preserved at -18 C orbelow,settingthe

temperature toolowincreases electricityconsumption.(This function doesnot need to be manually

When thescreenislocked, thebuttonA2is noteffective;just the ChildLock functioniconis enabled

when theA3buttonispressed, then theA4button power function is disabled.

Atthis time pleasecheckas per the followingprocedures: (1) Whether thedoorcloses and opens

well; (2) Whether thedoor is frequentlyopened,oritis opened for toolong at atime;(3)Too much

food isputinata time;if the aboveconditions existyoucancancel the alarm. Until the temperature

inside the freezerdrops to 0 Corbelow, thedisplayed HH willdisappear.

12

)

1

1.1

cover on the right side, then separate the terminal

connected to the top of the hinge

1.2

Use a crosshead screwdriver to loosen the hinge

screws. Remove the upper hinge

1.3

Move the door assembly upward to remove the door

assembly

2

2.1

cover on the left side of the cabinet. Install it into the

hole on the right side of the cabinet.

2.2

Remove the cover plate on the front of the cabinet

then pull the signal wire to the left side of the cabinet

2.3

Put the signal wire into the groove in the front cover

plate, and fasten it with the front cover plate

3

3.1

Dismantle the hinge shaft sleeve on the right side

and the cover on the left side of the door

3.2

Press the signal wire on the right side of the door into

the groove in the decorative strip, and close the

cover.

3.3

Pull out the signal wire from the groove in the left

side of the door, and push it into the hinge shaft

sleeve, then put it into the decorative strip

4

4.1

Dismantle the metal stopper cross-piece on the right

(Graphical representation in instruction booklet

last page.)

side of the door assembly, then install it in the corre

( & ).

-

sponding position on the left side of the door assem-

bly.

4.2

Use a crosshead screwdriver to remove the lower

hinge.

5

6

6.1

Install the door assembly onto the shaft on the

compartment assembly.

7

7.1

Take out the additional hinge and hinge cover from

the freezer drawer, and put the dismantled hinge and

hinge cover into a bag, and store them away.

7.2

Insert the hinge into the hole on the left side of the

door assembly, then use the screws to fasten the

hinge, and earth them by placing washers under-

neath the screws.

7.3

Connect the terminals on the cabinet to the terminals

on the door assembly, then fasten the hinge cover on.

)

(fig.1&2) (fig.3)

La page charge ...

Haier HF-255SAA Le manuel du propriétaire

Haier HF-255SAA Le manuel du propriétaire

dans d''autres langues

Documents connexes

Autres documents