Regulatory Compliance Information
FCC Compliance
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications to this product not
authorized by Apple could void the electromagnetic
compatibility (EMC) and wireless compliance and
negate your authority to operate the product.
This product has demonstrated EMC compliance
under conditions that included the use of compliant
peripheral devices and shielded cables between
system components. It is important that you use
compliant peripheral devices and shielded cables
between system components to reduce the possibility
of causing interference to radios, television sets, and
other electronic devices.
Responsible party (contact for FCC matters only):
Apple Inc.
One Apple Park Way, MS 911-AHW
Cupertino, CA 95014
USA
apple.com/contact
ISED Canada Compliance
This device complies with ISED Canada licence-
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’ISDE
Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’appareil doit accepter
tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le
fonctionnement.
CAN ICES-3 (B)/NMB-3(B)
Australia / New Zealand
EU / UK Compliance
Apple Inc. hereby declares that this wireless device
is in compliance with Directive 2014/53/EU and
Radio Equipment Regulations 2017. A copy of the
Declaration of Conformity is available at apple.com/
euro/compliance. Apple’s EU representative is Apple
Distribution International Ltd., Hollyhill Industrial
Estate, Cork, Ireland. Apple’s UK representative is
Apple UK Ltd., 2 Furzeground Way, Stockley Park,
Middlesex, UB11 1BB.
Japan VCCI Class B Statement
Medical device interference
MagSafe iPhone Riser contains magnets as well as
components and/or radios that may interfere with
medical devices. See important safety information in
the iPhone User Guide.
Exposure to radio frequency energy
The radiated output power of this device meets the
limits of FCC/IC radio frequency exposure limits. This
device should be operated with a minimum separation
distance of 20cm (8 inches) between the equipment
and a person’s body.
La puissance de sortie rayonné e cet appareil est
conforme aux limites de la FCC/IC limites d’exposition
aux fréquences radio. Cet appareil doit être utilisé avec
une distance minimale de séparation de 20 cm entre
l’appareil et le corps d’une personne.
-
1
