CLEANING
It is important that your refrigerator is kept clean to
prevent undesirable odors. Spilled food should be
wiped immediately, since it may acidify and
stain plastic surfaces if allowed to settle.
Never use metallic scouring pads, brushes,
coarse abrasive cleaners or strong alkaline
solutions on any surface.
Before you clean, remember that damp
objects will stick or adhere to extremely cold
surfaces. Do not touch frozen surfaces with
wet or damp hands.
EXTERIOR - Use a lukewarm solution of mild
soap or dish washable solution to clean the
durable finish of your refrigerator. Wipe with a
clean, damp cloth and then dry.
INTERIOR - Regular cleaning of the interior and
interior parts is recommended. Use a lukewarm
solution of mild soap or dish washable solution to
clean the durable finish of your refrigerator. Wipe
with a clean, damp cloth and then dry.
INTERIOR PARTS - Wash compartment
shelves, door racks, storage trays and magnetic
door seals etc. Use a lukewarm solution of mild
soap or dish washable solution to clean the
durable finish of your refrigerator. Wipe with a
clean, damp cloth and then dry.
Always remove power cord from the wall
outlet prior to cleaning. Wipe excess
moisture with a sponge or cloth to prevent
water or liquid from getting into any electrical
part and causing electric shock. Do not use
flammable or toxic cleaning liquids.
Caution for Cleaning - Not to use: Surface
active agent, Car wax, Anti-corrosive, All
sorts of oil, Gasoline, Acids, Wax.
Mild detergents, dish washable
solutions and soapy water can be used
Careless usage can lead to colour change.
19
GENERAL INFORMATION
Most power failures are corrected in an hour or two
and will not affect your refrigerator temperatures.
During power failures of longer duration, place a
block of dry ice on top of your frozen packages.
POWER FAILURE
IF YOU MOVE
Remove or securely fasten down all loose items
inside the refrigerator.
To avoid damaging the leveling screw(s), turn
them all the way into the base.
ANTI-CONDENSATION PIPE
The outside wall of the refrigerator cabinet may
sometimes get warm, especially just after
installation.
Don't be alarmed.
This is due to the anti-
condensation pipe, which
pumps hot refrigerant to
prevent "sweating" on the
outer cabinet wall.
Anti-Condensation
Pipe
Electrical Shock Hazard
Before replacing a burned-out light bulb,
either unplug the refrigerator or turn off power
at the circuit breaker or fuse box.
NOTE : Moving the control to OFF position
does not remove power from the light circuit.
WARNING
Caution