MATTEO X72301 Guide d'installation

Marque
MATTEO
Modèle
X72301
Taper
Guide d'installation
INSTALLATION INSTRUCTIONS SHEET
X72301X72301
Please Note:START FROM HERE
▪
▪
▪
▪
▪
▪
Make sure power is completely off at the fuse box.
Have your fixture installed by a qualified licensed
electrician
Prepare everything in clear area.
Wear gloves at all times during this installation.
Read instructions carefully before you start assembly.
Keep this instruction sheet for future reference.
Technical Support:1-844-628-8368
• All Matteo Lighting fixtures come with pre-wired module(s).
• Unless instructed to do so, please do not touch any part of the module(s) as any
unnecessary contact with the module could cause permanent damage.
THIS LUMINAIRE MUST BE MOUNTED OR SUPPORTED IN A JUNCTION BOX
CE LUMINAIRE DOIT ÊTRE MONTÉ OU SUPPORTÉ DANS UNE BOÎTE
DE JONCTION
House
white
Fixture
white
Fixture
black
House
black
House
ground
www.matteolighting.com
Toll Free. 1.844.628.8368 E. [email protected]
1
2
3
4
5
6
7
Ensure main supply is switched off.
Fit mounng bracket(1) onto mounng surface with
self-tapping screws(2).
Make wire(7) across rods(6), canopy(4) in order, and
screw down all rods.
Connect wires(3) according to color (White to White, Black to Black).
Connect all earth plug together onto the crossbar with green
screw to ght.
Fit ceiling plate(4) onto mounng bracket with nuts(5).
Connect poles(6) and onto ceiling plate, the other end to lampholder.
Install the lamps(9) firmly into lampholders.
8Fit lamp shade(10) into lampholders with nuts(8).
9Reconnect power.
  • Page 1 1

MATTEO X72301 Guide d'installation

Marque
MATTEO
Modèle
X72301
Taper
Guide d'installation
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents