emotn DBRC-07 Manuel utilisateur

Marque
emotn
Modèle
DBRC-07
Taper
Manuel utilisateur
BLE and Infrared remote control manual
The remote control has two modes: infrared and bluetooth
1. The indicator color of the remote control is Red
2. When Bluetooth is not connected, the LED flashes once every time you press the button; For
a long time, the LED still flickers once and then goes out;
3. During Bluetooth pairing,LED flash slowly with a period of 500ms; If the connection is
successful, steady on for about 3 seconds and then off
4. When Bluetooth is connected, the LED does not blink when pressed
5. Bluetooth pairing:Press the "right" and "Vol-" keys of the remote control at the same time,
release when the LED blinks, the remote control will send the broadcast packet, and then operate
on the host side for pairing.
6. The name of Bluetooth device is Emton
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device
,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates
,
uses and can radiate radio frequency energy and
,
if not installed
and used in accordance with the instructions
,
may cause harmful interference to radio
communications. However
,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception
,
which can be determined by turning the equipment off and on
,
the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
FCC Statement：
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
u
This device can be used without restricted.
ndesired operation.
IC STATEMENT
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
  • Page 1 1
  • Page 2 2

emotn DBRC-07 Manuel utilisateur

Marque
emotn
Modèle
DBRC-07
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents