Arlo Home Security System All-in-One Sensor (MS1001) Guide de démarrage rapide

Taper
Guide de démarrage rapide
© Arlo Technologies, Inc. Arlo, Arlo logo, and Every Angle Covered
are trademarks of Arlo Technologies, Inc. Any other trademarks are
for reference purposes.
Si ce produit est vendu au Canada, vous pouvez accéder à ce
document en français canadien à arlo.com/docs.
(If this product is sold in Canada, you can access this document in
Canadian French at arlo.com/docs.)
For regulatory compliance information including the EU
Declaration of Conformity, visit www.arlo.com/about/regulatory/.
Arlo Technologies, Inc.
2200 Faraday Avenue, Suite 150
Carlsbad, CA 92008 USA
Add an All-in-One Sensor to
your Home Security System
August 2022
Aer you install your Keypad Sensor Hub, you can
use the Arlo Secure App to add All-in-One Sensors.
To install your All-in-One Sensor:
1. Open the Arlo Secure App and tap the “+” icon to
add device.
2. Follow the setup instructions for your All-in-One
Sensor.
Note: The sensor is for indoor use only. The
Arlo Secure App shows you how to separate
and reattach the front module from the back
housing.
Do not attach the sensor adhesive unless the app
instructs you to do so. If you’re using the sensor
to detect water leaks, the adhesive isn’t needed.
201-50587-03
All-in-One Sensor
What’s in the box Need help?
We are here for you.
Visit www.arlo.com/support for quick answers and:
How-to videos
Troubleshooting tips
Additional support resources
Sensor
Adhesive
Flat Wall Plate with
Short Screw and Anchor
Corner Wall Plate with
Long Screw and Anchor
Magnet with
Adhesive
Note: Your sensor might not need a wall plate,
depending on how it will be used. The Arlo
Secure App explains this during setup.
  • Page 1 1
  • Page 2 2

Arlo Home Security System All-in-One Sensor (MS1001) Guide de démarrage rapide

Taper
Guide de démarrage rapide