Osram NINAB30 Manuel utilisateur

NINAB30
Osram
Marque
Osram
Modèle
NINAB30
Taper
Manuel utilisateur
USER MANUAL
FCC ID: 2AX8R-NINAB30
IC: 26725-NINAB30
Regulatory Compliance and Safety Information for NINA-B306 USA & Canada
Compliance
FCC Part 15, Subpart B / ICES-003 Unintentional Emissions Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules and
Industry Canada ICES-003. These limits are designed
to
provide reasonable protection against harmful interference when the equipment is operated in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules and Industry Canada ICES-003. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire
de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.
IMPORTANT! Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority
to operate this equipment.
IMPORTANT! Tous les changements ou modifications pas expressément approuvés par la partie
responsable de la conformité ont pu vider
l’autorité de l’utilisateur pour actionner cet équipement.
Compliance of this equipment is confirmed by the following label that is placed on the equipment:
FCC Part 15, Subpart C / RSS-210 Intentional Emissions Interference Statement
Compliance of this equipment is confirmed by the following certification numbers that are placed on the
equipment:
Notice: The term “FCC ID:” and “IC” before the certification number signifies that FCC and Industry
Canada technical specifications were
met.
Contains:
FCC ID:2AX8R-NINAB30
IC: 26725-NINAB30
RF Radiation Exposure Statement
This equipment complies with the FCC/IC radiation exposure limits set fourth for portable transmitting
devices operation in an uncontrolled
environment. End users must follow the specific operating
instructions to satisfy RF exposure compliance.
•
The equipment should only be used or installed at locations where there is normally at least
a 20cm separation between the
antenna and all persons.
•
This transmitter must not be co-located or operation in conjunction with any other antenna or
transmitter.
•
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to
operate this equipment.
  • Page 1 1
  • Page 2 2

Osram NINAB30 Manuel utilisateur

NINAB30
Osram
Marque
Osram
Modèle
NINAB30
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents