Clover Network, Inc.
415 N Mathilda Ave
Sunnyvale, CA 94085, USA
Clover Flex
Model: C403 (Wi-Fi)
FCC ID: HFS-C403W
IC: 1787B-C403W
HVIN: C403W
Model: C403 (AT&T)
FCC ID: HFS-C403U
IC: 1787B-C403U
Model: C403 (Verizon)
FCC ID: HFS-C403V
Model: C403 (Europe)
The FCC IDs and IC certiicate are not applicable
Model: C403 (Argentina)
CNC ID: C-24204
The FCC IDs and IC certiicate are not applicable
EU Importer
Marketplace Merchant Solutions Ltd
Unit 9, Richview Oice Park, Clonskeagh, Dublin 14, Ireland
Waste Electrical and Electronic Equipment-WEEE
NOTE: This product is covered electronic equipment under the
European Union’s Waste from Electrical and Electronic Equipment
(“WEEE”) Directive (2012/19/EU). The WEEE Directive requires that
covered equipment be collected and managed separately from
typical household waste in all EU member states. Please follow the
guidance of your local environmental authority or ask the shop
where you purchased the product for collection or recycling options.
40 mm
1.5 in
Select regions
Ausgewählte Regionen
Algunas regiones
Certaines régions
Per alcune zone
Sommige regio’s
Note: The power cord shall be connected to
a grounded AC power outlet v5
34
2
1
6
5
Patent
clover.com/patents
Flex
Quick Start Guide
Kurzanleitung · Instructions de démarrage · Guía de inicio rápido
Guida introduttiva · Snelstartgids
clover.com/help
EU Declaration of Conformity
Hereby, Clover Network, Inc. declares that the radio equipment type,
C403 is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
eu.clover.com/eu-compliance
The frequency band and the maximum transmitted power in EU are
listed below:
WWAN
LTE Band3: 22.5 dBm (Conducted)
LTE Band7: 23 dBm (Conducted)
LTE Band20: 22 dBm (Conducted)
WLAN
2400MHz-2483.5MHz: 17.5 dBm (EIRP)
5150MHz-5250MHz: 19.5 dBm (EIRP)
5250MHz-5350MHz: 19.5 dBm (EIRP)
5470MHz-5725MHz: 22 dBm (EIRP)
Restrictions in
AT/BE/BG/CZ/DK/EE/FR/DE/IS/IE/IT/EL/ES/CY/LV/LI/LT/LU/HU/MT/NL/NO
/PL/PT/RO/SI/SK/TR/FI/SE/CH/UK/HR. 5150MHz-5250MHz is for indoor
use only.
Caution: Exposure to Radio Frequency Radiation
This product complies with EU requirements regarding restriction of
exposure of persons to radio-frequency energy (RF) emitted by
telecommunication and radio devices as it is designed and
manufactured in such a way as not to exceed the exposure limits
indicated by the European Union Commission. The permitted SAR limit
for the general population is 2.0 W/Kg for body and 4.0 W/Kg for limb.
This limit guarantees an ample safety margin that protects all persons
regardless of age and health condition. SAR is measured with the device
at 5mm to the body and at 0mm to the extremity, while transmitting at
the highest certiied output power level in all frequency bands of the
device. The highest SAR level recorded for this model was equal to
body 1.44W/Kg, & limb 2.28 W/Kg.
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, (2) This device must accept any
interference received, including interference that may cause
undesired operation.
FCC Part 15 Class B-speciic
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
FCC Warning
Changes or modiications not expressly approved by the party
responsible for compliance could void the user‘s authority to operate
the equipment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The product comply with the FCC portable RF exposure limit set
forth for an uncontrolled environment and are safe for intended
operation as described in this manual. The further RF exposure
reduction can be achieved if the product can be kept as far as
possible from the user body or set the device to lower output power
if such function is available.
Innovation, Science and Economic Development Canada (ISED)
statement:
CAN ICES-3 (B)/NMB-3(B)
This device complies with ISED’s licence-exempt RSSs. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) le dispositif ne doit pas produire de brouillage
préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y
compris un brouillage susceptible de provoquer un fonctionnement
indésirable.
Caution:
(i) the device for operation in the band 5150-5250 MHz is only for indoor
use to reduce the potential for harmful interference to co-channel mobile
satellite systems;
(ii) the worst-case tilt angle(s) necessary to remain compliant with the
e.i.r.p. elevation mask requirement set forth in Section 6.2.2(3) shall be
clearly indicated.
(iii) Users should also be advised that high-power radars are allocated as
primary users (i.e. priority users) of the bands 5250-5350 MHz and
5650-5850 MHz and that these radars could cause interference and/or
damage to LE-LAN devices.
Avertissement:
Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des
instructions précises sur les restrictions susmentionnées, notamment :
(i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont
réservés uniquement pour une utilisation à l’intérieur ain de réduire les
risques de brouillage préjudiciable aux systèmes de satellites mobiles
utilisant les mêmes canaux;
(ii) les pires angles d’inclinaison nécessaires pour rester conforme à
l’exigence de la p.i.r.e. applicable au masque d’élévation, et énoncée à la
section 6.2.2 3), doivent être clairement indiqués.
(iii) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs
de radars de haute puissance sont désignés utilisateurs principaux
(c.-à-d., qu’ils ont la priorité) pour les bandes 5250-5350 MHz et
5650-5850 MHz et que ces radars pourraient causer du brouillage et/ou
des dommages aux dispositifs LAN-EL.
Radiation Exposure Statement:
The product complies with the Canada portable RF exposure limit set
forth for an uncontrolled environment and are safe for intended operation
as described in this manual. The further RF exposure reduction can be
achieved if the product can be kept as far as possible from the user body
or set the device to lower output power if such function is available.
Déclaration d'exposition aux radiations:
Le produit est conforme aux limites d'exposition pour les appareils
portables RF pour les Etats-Unis et le Canada établies pour un
environnement non contrôlé. Le produit est sûr pour un fonctionnement
tel que décrit dans ce manuel. La réduction aux expositions RF peut être
augmentée si l'appareil peut être conservé aussi loin que possible du
corps de l'utilisateur ou que le dispositif est réglé sur la puissance de
sortie la plus faible si une telle fonction est disponible.
Argentina:
NFC
-3.84 dBuA/m @ 10m
CE max SAR 10g
Body 1.44 W/Kg
Limb 2.28 W/Kg
Este producto utiliza para su funcionamiento una fuente de
alimentación, modelo FSP040-RHBN3 marca Clover con las
siguientes características técnicas: Entrada: AC 100-240 V,
50-60 Hz, 1.5 A, Cl. I; Salida: DC 12 V, 3.33 A, que ha sido
certiicada para su utilización en el mercado argentino.
Conectar una fuente diferente a la provista podría ocasionar
un incendio o choque eléctrico.
No utilice una fuente diferente a la provista con el equipo.
-
1
-
2
