Allen-Bradley 140G Series Guide d'installation

Taper
Guide d'installation
WARNING:
WARNUNG:
AVERTISSEMENT:
To prevent electrical shock, disconnect from power source before
installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o
manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
(Seguire i requisiti NFPA70E).
Vor Installations- oder Servicearbeiten Stromversorgung zur
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem
passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen
Sie die Anforderungen nach NFPA70E).
Avant le montage et la mise en service, couper l'alimentation
secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs. (Vous devez respecter la
norme NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o
del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a
instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de
contaminantes. (Cumpra as exigências da norma NFPA70E).
Installation - Installazione - Instalación
Instalação - -
140G-G-F____, 140G-H-F____, 140G-I-F____, 140G-J-F____, 140G-K-F____
Installation instruction for Flex Cable Operator for 140G-G through K
Istruzioni di installazione
Installationsanleitung
Instructions pour l’installation
Instrucciones de instalación
CLACK
Bul. 140G/140MG
M4 x .7 x 12 mm
140G-G
140G-H
140G-I
140G-J
140G-K
PN-353709
DIR 10000873178 (Version 05)
M4 x .7 x 12 mm
1/4-20 x .71 in
#10-32 x .22 in
#6-32 x .312 in
(2)
PN-353709
DIR 10000873178 (Version 05)
140G-K Shown
Provided with Circuit Breakers
U >0V
e
> 1.0” (25 mm)
Cable Length Diameter (Min.)
3 ft (0.9 m)
4 ft (1.3 m)
6 ft (1.9 m)
10 ft (3.0 m)
6.0”(152.4 mm)
12.0”(304.8 mm)
12.0”(304.8 mm)
12.0”(304.8 mm)
6.929 in
(176.0 mm)
1.181 in
(30.0 mm)
1.831 in
(46.5 mm)
4.370 in
(111.0 mm)
H
K
1
1
0.984 in
(25.0 mm)
1.378 in
(35.0 mm)
4.213 in
(107.0 mm)
4.803 in
(122.0 mm)
GI
1
10 - 15 lb-in
1.2 - 1.7 Nm
10 - 15 lb-in
1.2 - 1.7 Nm
(3)
PN-353709
DIR 10000873178 (Version 05)
140G-K
140G-G
140G-H
140G-I
140G-J
M4
M5
M4
M4
5.472 in
(139.0 mm)
1.378 in
(35.0 mm)
J
M4
2
3
(4)
10 - 15 lb-in
1.2 - 1.7 Nm
PN-353709
DIR 10000873178 (Version 05)
140G-K Shown
T-20
140G-M1, -P1 or -S1
(5)
4
5
PN-353709
DIR 10000873178 (Version 05)
140G-K Shown
140G-K Shown
Enclosures with Right Hand Flange Enclosures with Left Hand Flange
Enclosures with Right Hand Flange Enclosures with Left Hand Flange
90°
OFF
OFF
90°
7 - 11 lb-in
(0.8 - 1.2 Nm)
7 - 11 lb-in
(0.8 - 1.2 Nm)
3
3
3
3
2
1
1
2
2
1
2
1
#2
#2
7/16"
(11 mm)
7/16"
(11 mm)
30 - 40 lb-in
(3.5 - 4.5 Nm)
30 - 40 lb-in
(3.5 - 4.5 Nm)
PN-353709
DIR 10000873178 (Version 05)
(6)
CLACK
1 - Trip Breaker
2 - Reset Breaker
CLACK
See figure A
Vedi figura A
Siehe Abb. A
Voir figure A
Véase figura A
See figure A
Vedi figura A
Siehe Abb. A
Voir figure A
Véase figura A
See figure B
Vedi figura B
Siehe Abb. B
Voir figure B
Véase figura B
OK!
NO!
OK!
4 - Breaker Off
NO!
OK!
3 - Breaker On
NO!
OK!
CLACK
PN-353709
DIR 10000873178 (Version 05)
(7)
A
3/4"
(19 mm)
B
3/4"
(19 mm)
RESET
OFF
ON
PN-353709
DIR 10000873178 (Version 05)
Copyright © 2016 Rockwell Automation, Inc. All Rights Reserved. Printed in USA.
Publication 140G-IN128F-MU-P - March 2016
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Rockwell Automation maintains current product environmental information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/sustainability-ethics/product-environmental-compliance.page.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Allen-Bradley 140G Series Guide d'installation

Taper
Guide d'installation