emotn N1 Manuel utilisateur

N1
Marque
emotn
Modèle
N1
Catégorie
Projecteurs de données
Taper
Manuel utilisateur
User Manual
EMOTN N1 SMART PROJECTOR
English ···········································································
Deutsch ·········································································
Français ········································································
España ·········································································
Italiano ··········································································
日本語 ··········································································
繁體中文 ······························································ ······
01-12
13-00
00-00
00-00
00-00
00-00
00-00
Language Contents
Dear Customer ····································································02
Projection Size Description ···················································03
Packing List ·········································································04
Projector·············································································05
Remote Control····································································06
Remote Control Pairing·························································07
Network··············································································08
Focus ·················································································08
Keystone Correction ·····························································09
Inputs ·················································································09
Statement············································································10
Important Precautions ··························································· 12
Please read the product instruction carefully
Thank you for purchasing and using the products.For your safety and interests, you should read the Product Instruction carefully before using this
product.
About the product instruction:
The copyright of the instruction belongs to Super Creativity Limited.
Trademarks and names mentioned in the instruction belong to their respective right owners.In case of inconformity between the content of the
instructions and the actual product, the actual product shall prevail.
Dear Customer
* We reserves the right to interpret and modify the instructions.
We will not be liable for any personal injury, property, or other damage caused by your failure to comply with product instructions or precautions.
02
Projection Size Description
* The best recommended projection size is 100inches.
Size Screen
(Length*Width:cm)
3.15m
2.65m
2.2m
1.67m
120 inches
60 inches
80 inches
100 inches
177*100
221*124
265*149
80 inches
133*7560 inches
100 inches
120 inches
03
Adapter AC Cable
Projector
User Manual
Remote Control
Packing List
Before using this product, please check that all items are in the box.
04
Projector
Overview and interface description.
Rear view
DC IN Power buttonLine out Adjustable kickstand PTZ bracket socket
USB2.0
HDMI
LAN
Front view Bottom ViewTop View
05
Remote Control
Open the battery compartment cover of the remote control.
Install 2 AAA batteries. *
Put back the cover.
* Please insert new batteries according to the polarity indication.
06
Battery Compartment
Power
Turn on/off Projector Mute
Cuts off the sound temporality
Return
Reture to the previous page
OK
Press to confirm a selection or entry
Pause/resume play
Home
Access home page
Menu
Access more options during play
Focus Shortcut
Press:Pop-up manual focus icon
Press and hold:Auto focus
NETFLIX/YOUTUBE/PRIME VIDEO
Connect to the Video Streamming
Navigation
Volume Down/Volume Up
Place the remote control within 10cm of the device.
For first-time use, follow the on-screen instructions:Press "Volume Down" and "Right" simultaneously until an indicator light begins flashing.
This means that the remote control enters the pairing mode.
When the indicator light stops flashing,means connection is successful.
Remote Control Pairing
10 cm
Indicator light
Hold to press for pairing *
* If pairing is unsuccessful, repeat the above steps after the.
Remote control indicator light stops flashing.
07
Focus
Enter [Settings]--[Focus]
Select [Auto Focus],the screen will automatically clear.
Select [Manual Focus],press the remote control up/down button of
the navigation key to adjust the focus according to the displayed
screen.
When the screen is clear,stop the operation.
Network
Enter [Settings]--[Network]
Select the network of wired or Wi-Fi.
08
Keystone Correction
Enter [Settings]--[Keystone]
Select [Auto],the screen will be automatically corrected.
Select [Manual],to adjust the four points and the size of the frame.
Inputs
Enter [Inputs]--HDMI/HOME/USB
Watch the content from the difference singal sources.
09
ICSTATEMENT
CAN ICES-3 (B)/NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme canadienne ICES-003.
Thisdevicecontainslicence-exempttransmitter(s)/receiver(s)thatcomplywithInnovation,Science andEconomicDevelopmentCanada’s
licence-exemptRSS(s).Operationissubject tothefollowingtwoconditions:
(1)Thisdevicemaynotcauseinterference.
(2)Thisdevicemustacceptanyinterference,includinginterferencethatmaycause
undesiredoperationofthedevice
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1.L’appareil ne doit pas produire de brouillage;
2.L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
For projectors only
Thedistancebetweenuserandproductsshouldbenolessthan20cm.
La distance entre l'utilisateur et le produit ne doit pas être inférieure à 20 cm.
5.2GHzbandisrestrictedtoindooruseonly.
La bande de 5.2 GHz est réservée à l'usage intérieur.
10
We declares that this device is in compliance with the essential repuirements and other relevant provisions of Directive2014/53/EU.
Satisfies all the technical regulations applicable to the product within the scope of UK Radio Equipment Regulations (SI 2017/1206);
UK Electrical Equipment (Safety) Regulations (SI 2016/1101); and UK Electromagnetic Compatibility Regulations (SI 2016/1091).
This device operating frequency:2402-2480MHz(EIRP 20dBm),2412-2472MHz(EIRP 20dBm),5150~5250MHz(EIRP 23dBm),
5250~5350MHz(EIRP 20dBm),5470~5725MHz(EIRP 27dBm),5725~5850MHz(EIRP 13.98dBm).
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
11
Do not look directly at the projection beam with your eyes, because the strong beam may harm your eyes.
Do not block or cover the heat dissipation holes of the device to avoid affecting the heat dissipation of internal parts and damaging the device.
Keep away from humidity, exposure, high temperature, low pressure, and magnetic environment.
Do not place the device in areas susceptible to excessive dust and dirt.
Put the device to the flat and stable station, do not put it to the place prone to vibration.
Please use correct type of battery for the remote control.
Only use attachments/accessories specified or provided by the manufacturer.(such as the exclusive supply adapter,bracket etc)
Do not disassemble the device personally, repair the device only staff authorized by the company.
Place and use the device in an environment of 0°C-40°C.
Do not use the earphones for a long time. Excessive sound from the earphones can damage your hearing.
The plug considered as disconnect device of adapter.
As with any bright source, do not stare into the direct beam.
The adapter shall be installed near the equipment and shall be easily accessible.
Important Precautions
Manufactured under license from Dolby Laboratories. Dolby, Dolby Audio,and the double-D symbol are trademarks of Dolby Laboratories
Licensing Corporation.
HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing
Administrator, Inc.
12
Smart Projector
Model:N1
Input:19V 6.32A ,120.08W
USB Output:5V 1A
Manufacturer:Shenzhen Dangs Science and Technology Co.,Ltd.
For FAQs and more information,please visit:
https://www.emotn.com
[email protected]
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14

emotn N1 Manuel utilisateur

N1
Marque
emotn
Modèle
N1
Catégorie
Projecteurs de données
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents