red lion RAM-6021 Guide de démarrage rapide

Marque: red lion

Modèle: RAM-6021

Taper: Guide de démarrage rapide

QUICK START GUIDE

RAM-6021

WIRED ROUTER

UNPACKING INSTRUCTIONS

1. Unpack the Red Lion unit and verify the following components are

enclosed for the RAM-6021 Router: RAM-6021 & this quick start

guide.

2. There are 2 methods to provide power to the router:

• 4-pin screw terminal

• Side mounted 2.5mm barrel connector

The router requires a power source between 8 and 30 VDC to

operate:

3. Connect to the WAN or LAN port for network connectivity.

ACCESSING THE WEB USER INTERFACE

1. Connect PC to the RAM-6021 Router

Connect a CAT-5 Ethernet cable between the local PC and the

unit’s Ethernet port. Verify that the green LED is lit.

2. Setup PC IP Address

PC to Ethernet Interfaces

Select “Use the following IP address” and fill in the blank fields

with the information below:

3. Access Web User Interface

Open a web browser and enter the following in the address bar:

• WAN/ETH0: http://192.168.0.1:10000/

• LAN/ETH1: http://192.168.1.1:10000/

• User Name: admin (lowercase letters)

• Password: last six digits of the unit’s serial number

Upon successfully logging in, the web UI will launch.

Note: For security purposes, it is recommended that the admin pass-

word be changed according to your internal policies.

To change password, go to: Admin->Access Settings.

Web UI:

You are now connected to the web interface. If you should see anything

other than the screen shown above, please refer to the RAM-6021 User

Manual, located on our website: www.redlion.net.

For more information to set up Modbus features, please refer to the

RAM-6021 User Manual.

HARDWARE STATUS LEDs

RED LION CONTROLS TECHNICAL SUPPORT

If you have followed all of the instructions up to this point, are satisfied

that you are not having an authentication problem and your unit is still

not communicating, then it it is time to contact Red Lion Technical Sup-

port at [email protected] or 1-877-432-9908.

LABEL DESCRIPTION

GND Ground

PWR+ Power 8 to 30 VDC (12 or 24 VDC nominal)

IN Digital and analog input

OUT Digital output

For assistance with configuring your PC, see the appropri-

ate Microsoft support webpage listed at:

http://support.microsoft.com

WAN/ETH0 LAN/ETH1

IP Address 192.168.0.2 192.168.1.2

Subnet Mask 255.255.255.0 255.255.255.0

Default Gateway 192.168.0.1 192.168.1.1

Preferred DNS 192.168.0.1 192.168.1.1

LED State Description

Power ON Power is applied to the router

W View section 1.1.7 in Hardware Guide

RS232

ON Link established with serial device but

no data activity

FLASH Data transmitted/received with

attached serial device

Ethernet ON Link established with Ethernet device

Quick Start Guide

INSTALLATION AND HAZARDOUS AREA WARNINGS

All power, input and output I/O wiring must be in accordance with Class

I, Division 2 wiring methods are in accordance with the authority having

jurisdiction. This equipment is suitable for Use in Class 1, Division 2,

Groups A, B, C and D or Non-Hazardous Locations Only.

WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT

UNLESS POWER HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN TO

BE NON-HAZARDOUS.

WARNING - EXPLOSION HAZARD - SUBSTITUTION OF COMPONENTS

MAY IMPAIR SUITABILITY FOR CLASS I, DIVISION 2.

WARNING - EXPLOSION HAZARD - BATTERIES MUST ONLY BE

CHANGED IN AN AREA KNOWN TO BE NON-HAZARDOUS.

WARNING - EXPOSURE TO SOME CHEMICALS MAY DEGRADE THE SEAL-

ING PROPERTIES OF MATERIALS USED IN THE RELAYS.

AVERTISSEMENTS POUR INSTALLATION ET

ENDROITS DANGEREUX

Tout pouvoir, le câblage d'entrée et de sortie (I/O) doivent être con-

formes aux méthodes de câblage de Classe I, Division 2 et conformé-

ment à l'autorité compétente. Cet équipement est adapté pour une

utilisation en Classe1, Division 2, Groupes A, B, C et D ou endroits non-

dangereux seulement

AVERTISSEMENT - RISQUE D'AVERTISSEMENT - NE DÉBRANCHEZ PAS

L'ÉQUIPEMENT PENDANT QUE LE CIRCUIT EST DIRECT OU À MOINS

QUE L'ENVIRONNEMENT SOIT CONNU POUR ÊTRE NON-DANGEREUX.

AVERTISSEMENT - RISQUE D'EXPLOSION - LA SUBSTITUTION DE TOUT

COMPOSANT PEUT NUIRE À LA CONFORMITÉ DE CLASSE I, DIVISION 2.

AVERTISSEMENT - RISQUE D'EXPLOSION - LES BATTERIES DOIVENT

SEULEMENT ÊTRE REMPLACÉES DANS UNE ZONE RECONNUE COMME

ÉTANT NON-DANGEREUSE.

AVERTISSEMENT - L'EXPOSITION À CERTAINS PRODUITS CHIMIQUES

PEUT DÉGRADER LES PROPRIÉTÉS D'ÉTANCHÉITÉ DES MATÉRIAUX UTIL-

ISÉS DANS LES RELAIS ÉTANCHE PÉRIPHÉRIQUE.

red lion RAM-6021 Guide de démarrage rapide

Marque: red lion

Modèle: RAM-6021

Taper: Guide de démarrage rapide

Télécharger le PDF

rapport

dans d''autres langues

English: red lion RAM-6021 Quick start guide

red lion RAM-6021 Guide de démarrage rapide

red lion RAM-6021 Guide de démarrage rapide

dans d''autres langues

Documents connexes

Autres documents