Bestway Steel Pro 13’1″ x 6’11” x 32″ Above Ground Pool Le manuel du propriétaire

Marque: Bestway

Modèle: Steel Pro 13’1″ x 6’11” x 32″ Above Ground Pool

Taper: Le manuel du propriétaire

STEEL PRO™ POOLS

OWNER’S MANUAL

Visit Bestway YouTube channel

Para la instrucción en español,

visite bestwaycorp.com/support

WE SUGGEST NOT TO RETURN

THE PRODUCT TO THE STORE

QUESTIONS? PROBLEMS?

MISSING PARTS?

For FAQ, Manuals, Videos Or

Spare Parts, Please Visit

bestwaycorp.com/support

Put 1 in. to 2 in. water in the pool to cover the floor. Once pool floor is slightly covered,

gently smooth out all wrinkles. Start in the center of the pool and work your way clockwise

to the outside.

WARNING

smooth out the bottom

Prevent Young Children From Drowning:

Install fencing or approved barrier around all sides of pool.

State or local laws or codes may require fencing or other approved

barriers.

Check state or local laws and codes before setting up pool.

Drowning occurs silently and quickly. Assign an adult to supervise pool

and wear provided water watcher tag.

Keep children in your direct sight when they are in or near pool and

when you are filling and emptying pool.

When searching for a missing child, check pool first, even if you think

your child is in the house.

Pool presents a drowning hazard even during filling and draining of the

pool. Maintain constant supervision of children and do not remove any

safety barriers until the pool is completely empty and stowed away.

Refer to the list of barrier recommendations and guidelines as

described in CPSC Publication No.362.

Assign an adult to be responsible for watching children in the pool.

Give this person a “water watcher” tag and ask that they wear it the

entire time they are in charge of supervising children in the pool. If they

need to leave for any reason, ask this person to pass the “water

watcher” tag and the supervision responsibility to another adult.

Locate pumps and filters in such a way that children cannot climb on

them to gain access to pool.

If you have a ladder, refer to the ladder's manual for instructions.

If you have a pump, refer to the pump's manual for instructions.

Prevent Young Children From Gaining Access to Pool:

Remove pool ladders before leaving pool. Toddlers can climb ladder

and get into pool.

Position furniture away from pool so that children cannot climb and

gain access to pool.

When leaving pool, remove floats and toys from pool that might attract

a child.

Be Prepared to Respond to an Emergency:

Keep a working phone and list of emergency numbers near pool.

Become certified in cardiopulmonary resuscitation (CPR) so you can

respond to an emergency.

Electrocution Risk:

Keep all electrical lines, radios, speakers, and other electrical devices

away from pool.

Do not place pool near or under overhead electrical lines.

Suction Risk:

Replacement pump should never exceed the maximum flow rate

marked on the suction fitting.

For further safety tips check out the following websites:

www.homesafetycouncil.org

http://www.safety-council.org/info/child/water.html

www.safekids.org

www.nspi.org

Safety Barrier Guidelines for Residential Swimming Pool

Section I: Outdoor swimming pool

An outdoor swimming pool, including an inground, aboveground, or

onground pool, hot tub, or spa, should be provided with a barrier which

complies with the following:

1. The top of the barrier should be at least 48 inches above grade

measured on the side of the barrier which faces away from the

swimming pool. The maximum vertical clearance between grade

and the bottom of the barrier should be 4 inches measured on the

side of the barrier which faces away from the swimming pool.

Where the top of the pool structure is above grade, such as an

aboveground pool, the barrier may be at ground level, such as the

pool structure, or mounted on top of the pool structure. Where the

barrier is mounted on top of the pool structure, the maximum

vertical clearance between the top of the pool structure and the

bottom of the barrier should be 4 inches.

2. Openings in the barrier should not allow passage of a 4-inch

diameter sphere.

3. Solid barriers, which do not have openings, such as a masonry or

stone wall, should not contain indentations or protrusions except

for normal construction tolerances and tooled masonry joints.

4. Where the barrier is composed of horizontal and vertical members

and the distance between the tops of the horizontal members is

less than 45 inches, the horizontal members should be located on

the swimming pool side of the fence. Spacing between vertical

members should not exceed 1-3/4 inches in width. Where there are

decorative cutouts, spacing within the cutouts should not exceed

1-3/4 inches in width.

5. Where the barrier is composed of horizontal and vertical members

and the distance between the tops of the horizontal members is 45

inches or more, spacing between vertical members should not

exceed 4 inches. Where there are decorative cutouts, spacing

within the cutouts should not exceed 1-3/4 inches in width.

6. Maximum mesh size for chain link fences should not exceed 1-3/4

inch square unless the fence is provided with slats fastened at the

top or the bottom which reduce the openings to no more than 1-3/4

inches.

7. Where the barrier is composed of diagonal members, such as a

lattice fence, the maximum opening formed by the diagonal

members should be no more than 1-3/4 inches.

8. Access gates to the pool should comply with Section I, Paragraphs

1 through 7,and should be equipped to accommodate a locking

device. Pedestrian access gates should open outward, away from

the pool, and should be self-closing and have a self-latching

device. Gates other than pedestrian access gates should have a

self-latching device. Where the release mechanism of the

self-latching device is located less than 54 inches from the bottom

of the gate, (a) the release mechanism should be located on the

pool side of the gate at least 3 inches below the top of the gate and

(b) the gate and barrier should have no opening greater than 1/2

inch within18 inches of the release mechanism.

9. Where a wall of a dwelling serves as part of the barrier, one of the

following should apply:

(a) All doors with direct access to the pool through that wall should

be equipped with an alarm which produces an audible warning

when the door and its screen, if present, are opened. The alarm

should sound continuously for a minimum of 30 seconds within

7 seconds after the door is opened. Alarms should meet the

requirements of UL2017 General-Purpose Signaling Devices

and Systems, Section 77. The alarm should have a minimum

sound pressure rating of 85 dBA at 10 feet and the sound of the

alarm should be distinctive from other household sounds, such

WARNING

IMPORTANT SAFETY INSTRUCTIONS

Read and Follow All Safety Information

and Instructions.

Keep for future reference.

Failure to follow these warnings and

instructions can result in serious injury or

death to users, especially children.

as smoke alarms, telephones, and door bells. The alarm should

automatically reset under all conditions. The alarm should be

equipped with manual means, such as touchpads or switches,

to temporarily deactivate the alarm for a single opening of the

door from either direction. Such deactivation should last for no

more than 15 seconds. The deactivation touchpads or switches

should be located at least 54 inches above the threshold of the

door.

(b) The pool should be equipped with a power safety cover which

complies with ASTM F1346-91 listed below.

self-latching devices, are acceptable so long as the degree of

protection afforded is not less than the protection afforded by

(a) or (b) described above.

10. Where an aboveground pool structure is used as a barrier or where

the barrier is mounted on top of the pool structure, and the means

of access is a ladder or steps, then (a) the ladder to the pool or

steps should be capable of being secured, locked or removed to

prevent access, or (b) the ladder or steps should be surrounded by

a barrier which meets Section I, Paragraphs 1 through 9. When the

ladder or steps are secured, locked, or removed, any opening

created should not allow the passage of a 4-inch diameter sphere.

Section II: Barrier Locations

Barriers should be located so as to prohibit permanent structures,

equipment or similar objects from being used to climb the barriers.

NOTE: If your purchased pool set do not have any circulation

system, you can purchase separately. But please make sure the

equipment can turn over total volume of pool water no less than once

every 12 hr. You can check the water capacity on packaging to select

suitable circulation system. Pump provided for the circulation of water

shall be tested by a Nationally Recognized Testing Laboratory and

certified to conform to UL1081.

Also make sure the selected suction outlet sold with the pump should

be tested by a Nationally Recognized Testing Laboratory and certified

to conform to ASME/ANSI A112.19.8 or its successor standard

ANSI/APSP-16, in order to prevent suction entrapment.

Please read carefully and keep for future reference.

CHOOSE THE CORRECT LOCATION

The surface chosen to install the pool must respect the following

technical characteristics:

1. Because of the combined weight of the water inside the pool and

the pool users, it is extremely important that the surface chosen to

install the pool is capable of uniformly supporting the total weight

for the entire time the pool is installed. When choosing the surface,

take into consideration that water may come out of the pool when

in use or in the rain. If the water softens the surface, it may lose its

capability to support the pool weight.

2. Check regularly the position of the vertical legs and the U-supports.

They must be on the same level as the bottom of the pool at all

times. If the vertical leg or the U-support starts to sink into the

ground, drain the water immediately to avoid the pool collapsing

WARNING

Keep all electrical lines, radios,

speakers, and other electrical

devices away from pool. Do not

place pool near or under overhead

electrical lines.

Electrocution Risk

Stay away from drains & suction fittings

WARNING

If drain or suction outlet cover is missing or broken, your hair, body,

and jewelry can get sucked into drain. You could be held under

water & drown! Do not use pool if drain or suction outlet cover is

missing or broken.

Prevent Drowning

WARNING

Children under 5 are at highest risk for drowning.

Closely watch children who are in or near this pool.

WARNING

You can break your neck and be

paralyzed!

No Diving

due to the uneven loading on the frame structure. Change the

location of the pool or modify the surface material.

3. We recommend positioning the pool away from any objects

children could use to climb into the pool.

4. Position the pool near an adequate drainage system to deal with

overflow or to discharge the pool.

5. The surface must be flat and smooth. If the surface is inclined or

uneven, it can create an unbalanced loading on the structure of the

pool. This situation can damage the welding point of the liner and

bend the frame. In the worst cases, the pool can collapse, causing

serious personal injury and/or damage to personal property.

6. The selected surface must be clear of any type of object. Due to

the weight of the water, any object under the pool could damage or

perforate the bottom of the pool.

7. The selected surface must be clear of aggressive plants and weed

species. Those types of strong vegetation could grow through the

liner and create water leakage. The grass or other vegetation that

may cause odor or slime to develop have to be eliminated from the

set-up location.

8. The selected location must not have overhead power lines or trees.

Be sure the location does not contain underground utility pipes,

lines or cables of any kind.

9. The selected position must be far from house entrance. Do not

position any equipment or other furniture around the pool. The

water that comes out of the pool during the use or due to a faulty

product can damage the furniture inside the house or surrounding

the pool.

10. The selected surface must be flat and without holes that can

damage the material of the liner.

Follow the important instructions above to choose the correct surface

and location to set up your pool. Damaged parts of the pool, due to the

fact that the set-up surface and location does not match the

instructions, will not be considered as manufacture defect and will

avoid the warranty and any service claims.

Suggested set-up surfaces: grass, ground, concrete, and all other

surfaces that respect the above set-up conditions.

Not suggested surfaces: mud, sand, gravel, deck, balcony, driveway,

platform, soft/loose soil or other surface that does not meet the above

set-up conditions.

NOTE: Check with your local city council for by-laws relating to

fencing, barriers, lighting and safety requirements and ensure you

comply with all laws.

NOTE: If have a filter pump, refer to the pump’s manual for

instructions.

NOTE: The ladder must match the pool size and should be

used only for entering and exiting the pool. It is forbidden to exceed the

permitted payload of the ladder. Check regularly if the ladder is

properly assembled.