Kangtai 98157USA Wireless Doorbell Manuel utilisateur
- Taper
- Manuel utilisateur
Wireless Doorbell Manual
Model No.: Receiver：98157USA,98190USA
Transmitter:90050USA,90058USA,90062USA,90070USA,90071USA
Brief Introduction: It's applicable for home, office, factory, hotel and
reception hall, making you not miss any visitor.
Device Installation/Uninstallation
A. Device Installation/Uninstallation
Plug the receiver in the mains and the device will be ready.
Function Detail
B1. Pairing
a. After the receiver has been plugged in the mains and a sound of DingDong is
heard, it means that the receiver has entered into the pairing mode, which will last
for about 30 seconds; then press the button of the transmitter, when a sound of
DingDong is heard, it means that the pairing process has been successfully made.
b. 30 seconds after the receiver being plugged in the mains, make a simple press
the "L" on the back panel and when a sound of DingDong is heard, it means the
doorbell has entered into the pairing mode.
B2. Melody Selection
Every simple press on the "M" button on the back panel will lead to a melody shift
in turn for the receiver. There are totally 16 melodies for selection.
B3. Remove Pairing Memory
When the doorbell is in the pairing mode, press the button inside the housing of
the transmitter, and when a double "DingDong" is heard, it means the pairing memory
has been successfully deleted.
Techincal Data
Working Frequency: 433.92Mhz;
Power Supply: 120V AC 60Hz
Working Range: ≥ 40m in open area;
Working Temperature: 0 ℃~ 35℃ ;
Transportation and Storage Temperature: 0℃ ~ 50℃
DingDong
DingDong
DingDong
Melody Selection
Delete
Caution:
This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
(Receiver); CR2032 3VDC(Transmitter)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
-
1
