Alarm Clock
2-in-1 Wireless Charger
Model: iOP18
Supports:
• Qi compatible phones (also works with plastic cases up to 3mm thick)
• AirPods with wireless charging case
Place Qi compatible device face up on the charging rest. Charging status will be indicated on display:
WIRELESS CHARGING
DC Jack
5V/3A
5W USB
DC 5V 3A
USB Charging Port
iOP18 - Instruction Sheet - English
Color: Black text on white paper (1C + 1C)
Size: 102 x 150 mm
Material: 85 gsm wood free paper
Aug. 10, 2021
Connect AC adapter to DC Jack, and plug into outlet.
Battery Backup Compartment*
(for clock accuracy)
- Press on the battery compartment
door and slide to release it.
- Insert 2 fresh AAA batteries in the
backup battery compartment. Make
sure polarity (+/–) matches.
- Close the battery compartment door.
TIME SET
REAR CONTROLS
ALARM SET
SET
- Press to increase/decrease
time & settings
*Before use, remove battery
pull tab from bottom panel.
CAUTION - RISK OF EXPLOSION IF
BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE
INSTRUCTIONS.
The socket-outlet shall be installed near
the equipment and shall be easily
accessible.
Low Backup Battery Indicator
Alarm Indicator
QI Charge Status Indicator
PM Indicator
CAUTION: Remove phone’s metal protective case before charging. Do not place magnetic or metal objects
on charger during charging. Qi compatible phones with metallic looking finishes will charge normally.
SNOOZE
- Press & Hold to Set Clock
- Use +/- to select 12/24 hour display
and press Time Set to confirm
- Use +/- to set hour and press
Time Set to confirm
- Use +/- to set minute and press
Time Set to confirm
- Continue steps to set year, month,
and date, and press Time Set to
confirm clock settings
- Press & Hold to Set Alarm
- Use +/- to select hour and press
Alarm Set to confirm
- Use +/- to select minute and press
Alarm Set to confirm
- Use +/- to select schedule (7 days,
weekdays, or weekends only) and press
Alarm Set to confirm
- Press and release to arm/disarm alarm
- When alarm is sounding, press Alarm
Set to disarm and reset for the next day
- Press to Snooze Alarm
- Press & Hold to Adjust Snooze Duration
(adjust with +/- and press Snooze to confirm)
- Press to Adjust Display Brightness
(cycle through Hi, Med, Low, and OFF)
Note: Icon may continue to blink slowly when iOS devices are fully charged.
Device is not charging or metal object detected (reposition device or remove metal object)
Rapid blinking icon:
iOP18_IS_081321-A
Printed in China
© 2021 SDI Technologies, Inc.
All rights reserved
FCC Information
This equipment should be installed and operated with minimum distance 20cm (8in) between the radiator & your
body
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ISED Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
The device comply with ISED RF exposure requirement, users can obtain Canadian information on RF exposure and
compliance.
This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your
body.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
L'appareil est conforme aux exigences d'exposition RF ISED, les utilisateurs peuvent obtenir des informations
canadiennes sur l'exposition aux RF et la conformité.
Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un environnement non
contrôlé.
Tout changement ou modification non expressément approuvé par la partie responsable de la conformité pourrait annuler
le droit de l'utilisateur à utiliser l'équipement.
CAN ICES-3 (B)
/
NMB-3(B), CAN RSS-216
/
CNR-216
DISPLAY ICONS
Time Set Indicator
Wireless Charging Area
(when icon appears, install 2 new
AAA batteries on bottom panel)
Slow blinking icon:
Solid icon:
Device is charging
Device is fully charged
Please heed all warning, read and follow all instructions and keep these instructions handy for future
reference.
1. Do not use this product near water.
2. Unplug unit and clean only with damp cloth. Stronger cleaning agents, such as Benzene, thinner or
similar materials can damage the surface of the unit.
3. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
4. Heat – This product should be situated away from heat sources such as radiators, heat registers, stoves
or other appliances (including amplifiers) that produce heat.
5. Only use attachments/accessories specified by the manufacturer.
6. Unplug this product during lightning storms or when unused for long periods of time.
7. Damage Requiring Service – This product should be serviced by qualified service personnel when:
- Plug has been damaged.
- Objects have fallen into or liquid has been spilled into the enclosure.
- The unit has been exposed to rain.
- The unit has been dropped or the enclosure damaged.
- The unit exhibits a marked change in performance or does not operate normally.
8. No naked flame sources, such as lighted candles, should be placed on this product.
9. Attention should be drawn to the environmental aspects of battery disposal.
10. This product is suitable for use in tropical and/or moderate climates.
WARNING:
- To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
- The mains plug of power adaptor is used as the disconnect device, it shall remain readily operable.
- Do not dispose of batteries in the household trash or fire.
IMPORTANT SAFETY INSTRUCTIONS
-
1
dans d''autres langues
- English: iHome iOP18 User manual
Documents connexes
-
iHome IW30 Manuel utilisateur
-
iHome iW24 POWERVALET 2-in-1 Wireless Charger Manuel utilisateur
-
-
iHome iBTW281V2 TimeBoost Glow Wireless Charging + LED Color Changing Mode d'emploi
-
-
iHome iW23 Manuel utilisateur
-
iHome iW18 Bedside/Office Clock Mode d'emploi
-