FCC ID : 2AET4RUT360
FCC Regulations
（15C）This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
(15B)This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Intormation
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled enviroment.
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter and must be installed to
provide a separation distance of at least 20cm from all persons.
IC ID : 26511-RUT360
Canada Regulations:
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject
to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présentappareilestconforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitationestautorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le
brouillageest susceptible d’encompromettre le fonctionnement.
This transmiter must not be co-located or operatng in conjuncton with any other antenna or
transmiter. This
equipment should be installed and operated with a minimum distance of 20 centmeters
between the radiator and your
body.
Cet émeteur ne doit pas être Co-placé ou ne fonctonnant en même temps qu’aucune autre
antenne ou émeteur.
Cet équipement devrait être installé et actonné avec une distance minimum de 20 centmètres
entre le radiateur et
votre corps.
-
1
-
2
-
3
-
4
dans d''autres langues
- English: TELTONIKA Networks RUT360 User guide
Autres documents
-
Testo 316I Manuel utilisateur
-
TP-LINK EAP110 Omada Outdoor Access Point Mode d'emploi
-
Smart SRSM.ENV-SENSOR.01 Manuel utilisateur
-
-
TP-LINK tp-link T120200-2B1 Ceiling Mount EAP Manuel utilisateur
-
TP-LINK EAP110 300Mbps Wireless N Ceiling Mount Manuel utilisateur
-
-
TP-LINK tp-link Omada EAP660 HD V1 Ceiling Mount Access Point Le manuel du propriétaire
-
TP-LINK tp-link EAP660 HD Ceiling Mount EAP Mode d'emploi
-
Yale Assure Lock SL Key Free Touchscreen Deadbolt YRD256 Mode d'emploi