Eufy T8441 Mode d'emploi

Taper
Mode d'emploi
01 02 03 04 05 06
QUICK START GUIDE
Outdoor Cam Pro / Outdoor Cam
Powering On the Device
Connect the micro USB connector to the Outdoor Cam Pro / Outdoor
Cam’s micro USB port and the other end to a power adapter. Then
plug the power adapter into a power outlet. Wait until the camera
status LED turns solid blue.
Setting up the System
Download the eufy Security app from the App Store (iOS devices)
or Google Play (Android devices). Create an account and tap “Add
Device” to add Outdoor Cam Pro / Outdoor Cam to your device list.
Follow the on-screen instructions to complete the setup.
Mounting the Camera
A. Place the camera on a table
Attach the bottom of your camera to the magnetic base and place it
on the table.
B. Mount the camera onto a wall
Note
Before mounting the camera:
• Unplug the USB cable from the power adapter.
• Find a spot where the camera can easily reach a power outlet.
• Make sure the camera receives a strong Wi-Fi connection in the spot
you want to mount it so that it can stream video to your
eufy Security app.
• A 3M adhesive strip is provided for people who don’t want to drill
holes in the wall. Adhere the metallic plate with the 3M adhesive strip
after fastening the charging cable under the metallic plate’s hook.
1. Drill a pilot hole using a power drill. Install the metallic plate using
the provided anchors (optional) and screws. Anchors are needed
for walls that are made of brick or concrete. Make sure there is
enough space for the charging cable to run through before you fix
the screws.
A
B
Product Overview
Outdoor Cam Pro / Outdoor Cam
1
2
3
4
5
6
7
Spotlight
Lens
Status LED
Microphone
Micro USB port
• Connect to a USB charger
SYNC button
microSD card slot
Insert a microSD card to
store recordings
07 08 09 10 11 12
2. Attach the magnetic base to the metallic plate. Attach the Outdoor
Cam Pro / Outdoor Cam onto the magnetic base.
3. Rotate the camera to adjust the view and check it using the live
stream which you can access in the eufy Security app.
Tip: For more details, check the online manual:
https://www.eufylife.com/support
Notice
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation
between the equipment and receiver. (3) Connect the equipment into an outlet on a
circuit different from that to which the receiver is connected. (4) Consult the dealer or an
experienced radio/ TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device
can be used in fixed/mobile exposure condition. The min separation distance is 20cm.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables to
maintain compliance with FCC regulations.
The following importer is the responsible party
Company Name: POWER MOBILE LIFE, LLC
Address: 400 108th Ave NE Ste 400, Bellevue, WA 98004-5541
Telephone:1-800-988-7973
This product complies with the radio interference requirements of the
European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU.For the
declaration of conformity, visit the Web site:
https://www.eufylife.com/.
This product can be used across EU member states.
The adapter shall be installed near the equipment and shall be easily accessible.
Do not use the Device in the environment at too high or too low temperature, never
expose the Device under strong sunshine or too wet environment.
The suitable temperature for T8441 and accessories is 0°C-40°C.
When charging, please place the device in an environment that has a normal room
temperature and good ventilation.
It is recommended to charge the device in an environment with a temperature that
ranges from 5°C~25°C.
Please ensure to use only the charger offered by the manufacturer. Using unauthorized
charger may cause danger and violate the authorization of the device and the guarantee
article.
This charger is for indoor use only.
The charger type is TEKA-UCA10EU, output voltage/current is 5Vdc/1A. The plug
considered as disconnect device of adapter.
RF exposure information: The Maximum Permissible Exposure (MPE) level has been
calculated based on a distance of d=20 cm between the device and the human body. To
maintain compliance with RF exposure requirement, use product that maintain a 20cm
distance between the device and human body.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
Wi-Fi Operating Frequency Range:2412~2462MHz ; Wi-Fi Max Output Power:
15.58dBm
Bluetooth Operating Frequency Range: 2402~2480MHz; Bluetooth Max Output
Power: 5.921dBm(EIRP)
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807 Munich,
Germany
Anker Technology (UK) Ltd I Suite B, Fairgate House, 205 Kings Road, Tyseley,
Birmingham, B11 2AA, United Kingdom
This product is designed and manufactured with high quality materials and
components, which can be recycled and reused.
This symbol means the product must not be discarded as household waste,
and should be delivered to an appropriate collection facility for recycling.
Proper disposal and recycling helps protect natural resources, human health
and the environment. For more information on disposal and recycling of this
product, contact your local municipality, disposal service, or the shop where
you bought this product.
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device."
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement."
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
IC RF Statement:
When using the product, maintain a distance of 20cm from the body to ensure compliance
with RF exposure requirements.
Lors de l'utilisation du produit, maintenez une distance de 20 cm du corps afin de vous
conformer aux exigences en matière d'exposition RF.
Customer Service
Warranty
12-month Limited Warranty
Call Us
United States +1 (800) 988 7973 Mon-Fri 9AM-5PM (PT)
United Kingdom +44 (0) 1604 936 200 Mon-Fri 6AM-11AM (GMT)
Germany +49 (0) 69 9579 7960 Mon-Fri 6:00-11:00
Email Us
Customer Support: [email protected]
Anker Innovations Limited
Room 1318-19,Hollywood Plaza,610 Nathan
Road,Mongkok,Kowloon,Hong Kong
@EufyOfficial @EufyOfficial @EufyOfficial
Anker Innovations Limited. All rights reserved. eufy Security and eufy Security Logo are
trademarks of Anker Innovations Limited, registered in the United States and other
countries. All other trademarks are the property of their respective owners.
51005002602 V01
  • Page 1 1
  • Page 2 2

Eufy T8441 Mode d'emploi

Taper
Mode d'emploi

dans d''autres langues