Arlo Safety and Compliance Information

Safe Handling and Usage Guidelines for Removable

and Rechargeable Battery Packs

Improper battery pack use may cause it to EXPLODE, CATCH FIRE, and/or CAUSE BURNS if

disassembled, punctured, cut, crushed, short circuited, incinerated,

recharged (disposable cells), or exposed to water, fire, or high

temperatures

To ensure optimal safety and performance:

• Only use Arlo or carrier approved battery packs. Use of an unqualified battery or charger may present a risk of fire, explosion, leakage, or other hazard. If you

• DO NOT disassemble, crush, puncture, short external contacts, or

dispose of in fire or water.

• DO NOT expose the battery to fire or temperatures greater than

60°C (140°F). Do not place the battery next to areas which may

become hot. Examples include, but are not limited to, on or near a

space heater, cooking surface, cooking appliance, iron, radiator, or

fireplace.

• DO NOT get the battery pack or the Arlo device wet. Even though

they might dry and appear to operate normally, the circuitry can

slowly corrode and defeat its safety circuitry

compartment is empty and free of any moisture or loose debris

before inserting the battery.

• AVOID dropping the battery pack or the Arlo device. Dropping it,

especially on a hard surface, might cause damage to the battery or

the Arlo device. If you suspect damage to the battery pack or the

Arlo device, replace it.

• ALWAYS follow the directions in the Quick Start Guide and/or

written in the Arlo Product User Manual.

• ALWAYS follow local waste and recycling laws and guidelines to

dispose of used battery packs.

other than Arlo rechargeable batteries in Arlo devices, including

without limitation, fire, damage to property, bodily injury, and/or death.

Compliance with 2014/53/EU Radio Equipment

Directive (RED)

This Arlo radio equipment complies with the requirement of Article

10 (2) of the RED as it can be operated in at least one Member State

without infringing applicable requirements on the use of radio

spectrum. This radio equipment also complies with Article 10 (10) as no

restrictions on putting it into service or requirements for authorization

of use exist.

FCC statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

IC statement

This device complies with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions

suivantes:

(1) l'appareil ne doit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement."

conjonction avec une autre antenne ou transmetteur.