Bunn JDF-2S Guide d'installation

Marque: Bunn

Modèle: JDF-2S

Taper: Guide d'installation

Ce manuel convient également à

INSTALLATION & OPERATING GUIDE

Bunn-O-Matic Corporation

Post Office Box 3227, Springfield, Illinois 62708-3227

Phone (217) 529-6601 | Fax (217) 529-6644

www.bunn.com

JDF-2S, JDF-4S

Silver Series®

JDF-2S & JDF-4S PH or PC with Non LIT or LIT Graphic Door

JDF-2S & JDF-4S PH or PC with LIT Segment Door

244744.2 031314

Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:

1) All coffee and tea dispensers/servers, MCR/MCP/MCA single cup brewers, and BUNNlink® electronic circuit and/or

control boards – 1 year parts and 1 year labor.

2) Product-speciﬁc warranties for Crescendo®, Fast Cup®, Sure Immersion®, Sure Tamp®, and others – 1 year parts

and 1 year labor. Please visit commercial.bunn.com/support/warranty-lookup for further details.

3) All other equipment – 2 years parts and 1 year labor plus added warranties as speciﬁed below:

a) Electronic circuit and/or control boards – parts and labor for 3 years.

b) Compressors on refrigeration equipment – 5 years parts and 1 year labor.

c) Grinding burrs on coffee grinding equipment for 4 years or 40,000 pounds of coffee, whichever comes ﬁrst.

These warranty periods run from the date of installation. BUNN warrants that the equipment manufactured by it will

be commercially free of defects in material and workmanship existing at the time of manufacture and appearing within

the applicable warranty period. This warranty does not apply to any equipment, component or part that was not manu-

factured by BUNN or that, in BUNN’s judgment, has been affected by misuse, neglect, alteration, improper installation

or operation, improper maintenance or repair, non periodic cleaning and descaling, equipment failures related to poor

water quality, damage or casualty. In addition, the warranty does not apply to replacement of items subject to normal

wear with use including but not limited to user replaceable parts such as seals and gaskets. This warranty is conditioned

on the Buyer 1) giving BUNN prompt notice of any claim to be made under this warranty by telephone at (217) 529-6601

or by writing to Post Ofﬁce Box 3227, Springﬁeld, Illinois 62708-3227; 2) if requested by BUNN, shipping the defective

equipment prepaid to an authorized BUNN service location; and 3) receiving prior authorization from BUNN that the

defective equipment is under warranty.

THE FOREGOING WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ANY OTHER WARRANTY, WRITTEN OR

ORAL, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF EITHER

MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. The agents, dealers or employees of BUNN

are not authorized to make modiﬁcations to this warranty or to make additional warranties that are binding on BUNN.

Accordingly, statements by such individuals, whether oral or written, do not constitute warranties and should not be

relied upon.

If BUNN determines in its sole discretion that the equipment does not conform to the warranty, BUNN, at its

exclusive option while the equipment is under warranty, shall either 1) provide at no charge replacement parts

and/or labor (during the applicable parts and labor warranty periods speciﬁed above) to repair the defective

components, provided that this repair is done by a BUNN Authorized Service Representative; or 2) shall replace

the equipment or refund the purchase price for the equipment.

THE BUYER’S REMEDY AGAINST BUNN FOR THE BREACH OF ANY OBLIGATION ARISING OUT OF THE

SALE OF THIS EQUIPMENT, WHETHER DERIVED FROM WARRANTY OR OTHERWISE, SHALL BE LIMITED, AT

BUNN’S SOLE OPTION AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND.

In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost proﬁts, lost sales, loss

of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment,

facilities or services, or any other special, incidental or consequential damages.

BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY

USER NOTICES

Carefully read and follow all notices on the equipment and in this manual. They were written for your protec-

tion. All notices are to be kept in good condition. Replace any unreadable or damaged labels.

27442.7000

00986.7000

12559.0003

00656.0001

44744.2 092517

CHARGE

Type R134A, Amount 255 g (9 oz)

GWP 1430, CO2 equivalent 0.36t

Design Pressures:

High 255 psi (17.6 bar) (1.76 MPa)

Low 36 psi (2.5 bar) (0.25 MPa)

Contains fluorinated greenhouse gases covered

by the Kyoto Protocol. Hermetically sealed system.

33461.0012 JDF-2S 220-230V 33461.0014 JDF-4S 220-230V

As directed in the International Plumbing Code of the

International Code Council and the Food Code

Manual of the Food and Drug Administration (FDA),

this equipment must be installed with adequate

backflow prevention to comply with federal, state

and local codes. For models installed outside the

U.S.A., you must comply with the applicable Plumb-

ing /Sanitation Code for your area.

Artwork for P/N: 00656.0001

Artwork Rev: A

Drawn: REF

Date: 04/22/10

HAZARDOUS

VOLTAGE

DISCONNECT FROM

POWER SOURCE

BEFORE REMOVING!

WARNING

Moving Parts.

Risk of Electrical Shock.

WARNING AVERTISSEMENT

Pièces amovibles.

Risk de choc électrique.

Ne pas utiliser l’appareil lorsque

le panneau est enlevé.

Debrancher le cordon

d’alimentation de l’appareil avant

de faire l’entretien.

Do not operate unit with

this panel removed.

Disconnect power

before servicing unit.

WARNING

Use only on a properly protected

circuit capable of the rated load.

Electrically ground the chassis.

Follow national/local electrical codes.

Do not use near combustibles.

Do not deform plug or cord.

AVERTISSEMENT

FAILURE TO COMPLY RISKS EQUIPMENT

DAMAGE, FIRE OR SHOCK HAZARD.

READ THE ENTIRE OPERATING MANUAL INCLUDING

THE LIMIT OF WARRANTY AND LIABILITY BEFORE

BUYING OR USING THIS PRODUCT.

THIS EQUIPMENT IS ENERGIZED AT ALL TIMES UNLESS

ELECTRICALLY DISCONNECTED.

TOUT MANQUEMENT À SE CONFORMER À CES DIRECTIVES PEUT

ENTRAINER DES DOMMAGES À L'ÉQUIPMENT OU PRODUIRE DES

DANGERS D'INCENDIE OU D'ÉLECTROCUTION.

VEUILLEZ LIRE LE MANUEL DE FONCTIONEMENT

EN ENTIER, Y COMPRIS LES LIMITES DE GARANTIES ET

RESPONSABILITÉS,AVANT D’ACHETER

OU D'UTILISER LE PRÉSENT PRODUIT.

L' ÉQUIPEMENT EST TOUJOURS SOUS TENSION

LORSQU'IL N'EST PAS DÉBRANCHÉ.

N'utilisez que sur un circuit protégé

adapté à la charge nominale.

Toujours mettre le boitier à la masse.

Se conformer aux codes national ou local

délectricité.

Garder les products combustibles á distance.

Ne pas déformer la fiche ou le cordon.

CHARGE

Type R134A, Amount 283 g (10 oz)

GWP 1430, CO2 equivalent 0.40t

Design Pressures:

High 335 psi (23 bar) (2.31 MPa)

Low 88 psi (6 bar) (0.61 MPa)

Contains fluorinated greenhouse gases covered

by the Kyoto Protocol. Hermetically sealed system.

33461.0001 JDF-2S 120V

CHARGE

Type R134A, Amount 10 oz (283 gm)

Design Pressures:

High 335 psi (23 bar) (2.31 MPa)

Low 88 psi (6 bar) (0.61 MPa)

33461.0000 JDF-4S 120V

CHARGE

Type R134A, Amount 9 oz (255 gm)

Design Pressures:

High 255 psi (17.6 bar) (1.76 MPa)

Low 36 psi (2.5 bar) (0.25 MPa)

CONTENTS

Warranty ........................................................................................................................ 2

User Notices .................................................................................................................. 3

Initial Set-Up & Electrical Requirements ........................................................................ 4

CE Requirements ........................................................................................................... 4

Initial Fill ........................................................................................................................ 5

Plumbing Requirements ................................................................................................ 5

Door Cover Installation .................................................................................................. 6

Plumbing Hookup .......................................................................................................... 7

Operating Controls ......................................................................................................... 9

Dispenser Use .............................................................................................................. 11

Portion Control Option ................................................................................................. 11

Adjustments & Optional Settings ................................................................................. 13

Cleaning ....................................................................................................................... 17

Function Lists .............................................................................................................. 20

Troubleshooting ........................................................................................................... 22

Quick Setup Guide ....................................................................................................... 28

444744.2 10/09/18

CE REQUIREMENTS

• This appliance must be installed in locations where it can be overseen by trained personnel.

• For proper operation, this appliance must be installed where the temperature is between 5°C to 32°C and 50%

humidity.

• Appliance shall not be tilted more than 10° for safe operation.

• An electrician must provide electrical service as speciﬁed in conformance with all local and national codes.

• This appliance must not be cleaned by water jet.

• This appliance can be used by persons aged from 18 years and above if they have been given supervision or

instruction concerning use of the appliance in a safe way and if they understand the hazards involved.

• Keep the appliance and its cord out of reach of children aged less than 18 years.

• Appliances can be used by persons 18 years and above with reduced physical, sensory or mental capabilities

or lack of experience and knowledge if they have been given supervision or instruction concerning use of the

appliance in a safe way and understand the hazards involved.

• Children under the age of 18 years should be supervised to ensure they do not play with the appliance.

• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel

with a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.

• Machine must not be immersed for cleaning.

• Cleaning and user maintenance shall not be made by children unless they are older than 18 years and supervised.

• This appliance is intended to be used in household and similar applications such as:

– staff kitchen areas in shops, ofﬁces and other working environments;

– by clients in hotels, motels and other residential type environments;

– bed and breakfast type environments.

• This appliance not intended to be used in applications such as:

– farm houses;

• Access to the service areas permitted by Authorized Service personnel only.

• The A-Weighted sound pressure level is below 70 dBA.

NORTH AMERICAN REQUIREMENTS

• This appliance must be installed in locations where it can be overseen by trained personnel.

• For proper operation, this appliance must be installed where the temperature is between 41°F to 90°F (5°C to

32°C) and 50% humidity.

• Appliance shall not be tilted more than 10° for safe operation.

• An electrician must provide electrical service as speciﬁed in conformance with all local and national codes.

• This appliance must not be cleaned by pressure washer.