ADEPT INDUSTRIES V2.0 Manuel utilisateur

Marque: ADEPT INDUSTRIES

Modèle: V2.0

Taper: Manuel utilisateur

user manual

1. Power on: Press the power button, and the blue indicator light starts to shine

2. BLE matching code: First turn on the power of eWheels, and then press the TFS power switch for more than 3 seconds in the shutdown state. The blue LED

starts flashing rapidly, and the TFS enters the matching state.When the blue LED continues to shine, the matching code is successful. If the blue LED is flashing

slowly, the code alignment failed. Please try again.

3. After successful yard matching and BLE connection, fix TFS on the golf bag and pull the opening of the rope towards the Head of eWheels.

4. Buckle the iron clip to the belt and attach the magnet to the clip. When you walk forward, the rope is pulled out, and when it is more than 1 metre,

eWheels follow at your pace. When you turn, eWheels follow the turn; When you stop, eWheels stop.

5. FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

eceiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

RF warning statement:

The device has been evaluated to meet general RF exposure requirement. The device can be used

in portable exposure condition without restriction.

Model：V2.0