KS 7632 Carlo Rechargeable Table Lamp Manuel utilisateur
- Taper
- Manuel utilisateur
Home » KS » KS 7632 Carlo Rechargeable Table Lamp Instruction Manual
Contents
1 KS 7632 Carlo Rechargeable Table
Lamp
2 Instruction
3 Documents / Resources
3.1 References
4 Related Posts
KS 7632 Carlo Rechargeable Table Lamp
KS 7632 Carlo Rechargeable Table Lamp Instruction Manual
Manuals+ — User Manuals Simplified.
Assembly and installation instructions
1. Connection and maintenance of the luminaire must be carried out by trained and qualified technicians only, in
compliance with the regulation in force.
2. Make sure there is no power connected to the fitting before carrying out any maintenance
3. LED risk group 0-1 IEC 62471. Do not stare at operating luminaire. It may be harmful to the eyes.
4. Place the inground luminaire on a 20-30cm drainage layer (gravel) and fill it with water, if after 30 minutes water
is still in the luminaire it is compulsory to integrate an additional draining system (e.g. drain pipe).
5. To avoid water stagnation, do not place the inground luminaire for installation on hollow areas.
6. If you disassemble the inground luminaires, projectors or bollards. Make the luminaires working for 30-60
minutes before to assemble them. In order to avoid the measure.
7. The protection rating of the electrical connection for the luminaires with factory pre-wired connection cable
must be equal to or greater than the IP67.
8. The protection rating of the electrical connection for projectors must be equal to or greater than the IP67
9. The protection rating of the electrical connection for inground luminaires must be equal to or greater than the
IP67
10. All luminaires are equipped with a H20 STOP system giving effective protection against water or moisture
passage along connecting cables.
11. If the external flexible cable or cord of the luminaire is damaged, it shall be exclusively replaced by the
manufacturer or qualified technician, in order to avoid a hazard.
12. Tighten and release screws alternatively or cross wise.
13. For an easy maintenance (unscrewing) of the luminaire we recommend protecting screws threads with silicone
grease before exposure to weather.
14. Keep the luminaire clean to prevent dirty deposit on frames and screws’ head. On stainless steel parts use
dedicated cleaners only.
15. Keep away from aggressive agents and chemical substances (e.g. fertilize, weed-killer, lime)
16. Do not use water high pressure cleaners.
17. Electronical equipment sensitive to voltage surges. The installation of a protection device against overvoltage
on the electrical system attenuates the intensity of these phenomena protecting apparatus from the risk of
damage.
18. In case of diffuser damage change it before to switch on the fitting.
19. Retain the instructions.
20. Technical data on the product rating label.
Instruction
De tekeningen zijn slechts ter illustratie. Het model van de lamp kan afwijkend zijn. Die Zeichnungen sind nur zur
Illustration. Sie können in Modell der Lampe variieren The drawings are for illustrative purposes only. They may
vary in model of the lamp. Les dessins ne sont donnés qu’à des fins d’illustration. Elles peuvent varier dans le
modèle de la lampe.
www.ks-verlichting.nl November 2019
Documents / Resources
KS 7632 Carlo Rechargeable Table Lamp [pdf] Instruction Manual
7633, 7634, 7635, 7632 Carlo Rechargeable Table Lamp, 7632, Carlo Rechargeable Table
Lamp, Rechargeable Table Lamp, Table Lamp, Lamp
-
1
-
2
-
3
-
4
-
5
-
6
-
7
