3
ENGLISH
1. RECOMMENDATIONS AND SUGGESTIONS
• The Instructions for Use apply to several versions of this
appliance. Accordingly, you may nd descriptions of indi-
vidual features that do not apply to your specic appliance.
• The manufacturer will not be held liable for any damages
resulting from incorrect or improper installation.
• The minimum safety distance between the cooker top
and the extractor hood is 650 mm (some models can be
installed at a lower height, please refer to the paragraphs
on working dimensions and installation).
• Check that the mains voltage corresponds to that indicated
on the rating plate xed to the inside of the hood.
• For Class I appliances, check that the domestic power sup-
ply guarantees adequate earthing. Connect the extractor to
the exhaust ue through a pipe of minimum diameter 120
mm. The route of the ue must be as short as possible.
• Do not connect the extractor hood to exhaust ducts car-
rying combustion fumes (boilers, replaces, etc.).
• If the extractor is used in conjunction with non-electrical
appliances (e.g. gas burning appliances), a sufcient de-
gree of aeration must be guaranteed in the room in order
to prevent the backow of exhaust gas. The kitchen must
have an opening communicating directly with the open
air in order to guarantee the entry of clean air. When the
cooker hood is used in conjunction with appliances sup-
plied with energy other than electric, the negative pressure
in the room must not exceed 0,04 mbar to prevent fumes
being drawn back into the room by the cooker hood.
• The air must not be discharged into a ue that is used for
exhausting fumes from appliances burning gas or other
fuels (not applicable to appliances that only discharge the
air back into the room).
• In the event of damage to the power cable, it must be
replaced by the manufacturer or by the technical service
department, in order to prevent any risks.
• If the instructions for installation for the gas hob specify
a greater distance specied above, this has to be taken
into account. Regulations concerning the discharge of air
have to be fullled.