2
SOME IMPORTANT NOTES
FCC NOTES
This system meets industry & government requirements and applicable standards.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions manual, may cause
interference to radio communications. It has been tested and found to comply with
limits for a Class A digital device pursuant to subpart B of Part 15 of FCC Rules,
which are designed to provide reasonable protection against interference when
operated in a commercial environment. Operation of this equipment in a residential
area is likely to cause interference in which case the user at his own expense will
be required to take whatever measures to correct the interference.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
CE CLASS A WARNING
This equipment is compliant with Class A of CISPR 32. In a residential
environment this equipment may cause radio interference.
AVERTISSEMENT CE CLASSE A
Cet équipement est conforme à la classe A de CISPR 32. Dans un environnement
résidentiel, cet équipement peut provoquer des interférences radio.
WARRANTY LIMITS
Warranty will terminate automatically when the machine is opened by any person
other than the authorized technicians. The user should consult his/her dealer for the
problem happening. Warranty voids if the user does not follow the instructions in
application of this merchandise. The manufacturer is by no means responsible for
any damage or hazard caused by improper application.
LIMITES DE GARANTIE
La garantie prend fin automatiquement lorsque la machine est ouverte par une
personne autre que les techniciens autorisés. L'utilisateur doit consulter son
revendeur pour le problème qui se produit. La garantie s'annule si l'utilisateur ne
suit pas les instructions d'application de cette marchandise. Le fabricant n'est en
aucun cas responsable de tout dommage ou danger causé par une mauvaise
application.
警告使用者
這是甲類的資訊產品，在居住的環境中使用時，可能會造成射頻干擾，在這
3
種情況下，使用者會被要求採取某些適當的對策。
SAFETY INSTRUCTIONS
This equipment is not suitable for use in locations where children are likely to be
present.
CONSIGNES DE SÉCURITÉ
Cet équipement ne convient pas à une utilisation dans des lieux pouvant accueillir
des enfants.
BATTERY CAUTION NOTES
Dispose of used batteries according to the instructions.
Replacement of a battery with an incorrect type that can defeat a safeguard
(for example, in the case of some lithium battery types)
Disposal of a battery into fire or a hot oven, or mechanically crushing or
cutting of a battery that can result in an explosion.
Leaving a battery in an extremely high temperature surrounding
environment that can result in an explosion or the leakage of flammable
liquid or gas.
A battery subjected to extremely low air pressure that may result in an
explosion or the leakage of flammable liquid or gas.
BATTERIE ATTENTION NOTES
Jetez les piles usagées conformément aux instructions.
Remplacement d'une batterie avec un type incorrect qui peut annuler une
sauvegarde (par exemple, dans le cas de certains types de batterie au
lithium)
Mise au rebut d'une batterie dans le feu ou dans un four chaud, ou
écrasement ou coupure mécanique d'une batterie pouvant entraîner une
explosion.
Laisser une batterie dans un environnement environnant à des températures
extrêmement élevées pouvant entraîner une explosion ou la fuite de liquide
ou de gaz inflammable.
Une batterie soumise à une pression atmosphérique extrêmement basse
pouvant provoquer une explosion ou une fuite de liquide ou de gaz
inflammable.
警告
本電池如果更換不正確會有爆炸的危險，請依製造商說明書處理用過之電
池。
4
Views
Front View
Rear View
10.1” PCAP
Touch Panel
VESA Mount 75 x 75 Hole (four M4-7.2L screws)
Expansion Slot
for Optional
Attachment
I/O Ports
Power Button
5
Side View
Rear I/O Ports
Connecting Power Adapter and I/O Cables
To have the terminal ready for operation, please connect the connector of
power adapter and all of the connectors of required I/O cables respectively to
the 12VDC-IN power jack and appropriate I/O ports. Please make sure that
each of the cables is fully connected to the correct port. Damages due to
incorrect connection or orientation are not covered by product warranty!
Some cable connectors like the connectors of LAN cables have to be gently
inserted until a click is heard. And please make sure that each connector has to
be connected to the right peripheral device in the right way.
CAUTION: On doing insertion or extraction of a cable connector, please
always hold the connector head itself instead of pulling the cable wire.
Doing this could damage the cables and ports, which is considered as an
artificial damage and is not covered by the warranty. The means of power
USB 2.0 Ports
LAN Port
12V DC-IN Power Jack
Power Status LED Indicator
6
cord should be connected to a socket-outlet with earthing connection.
ATTENTION: Lors de l'insertion ou de l'extraction d'un connecteur de
câble, veuillez toujours tenir la tête du connecteur elle-même au lieu de
tirer le fil du câble. Cela pourrait endommager les câbles, ce qui est
considéré comme un dommage artificiel et n'est pas couvert par la
garantie. Le cordon d'alimentation doit être connecté à une prise de
courant avec mise à la terre.
Powering ON/OFF the POS Terminal
Power ON PC-2011/2111
Press down the power button to power on the PC-
2011/2111.
Power OFF PC-2011/2111
In most cases, push the power button again to power the
system off. However, if the POS box halts for unknown
reasons, please be advised to hold the power more than
10 seconds to initiate a forced shutdown.
Status LED Indicator
There is a power status LED indicator on the left side of the PC-2011/2111.
After powering ON the POS system, you can read the system operation status
from the power status LED indicators. The LED status is described below.
LED
Status
Description
POWER
Blue
System power ON
Orange
System standby
Installing Optional Peripheral Devices
PC-2011/2111 can work with multiple optional upgrade kits, such as MSR,
Smart Card Reader and the like. For the detailed instructions, refer to the user
manual related to each peripheral devices. Before installing an optional
peripheral device, make sure that the system is powered off to prevent electric
hazard! Failure to follow the warning description will void the product
warranty!
Installing an Operating System
This product is highly professional equipment. Therefore, we do NOT
encourage you to install any operating system into this machine without
professional assistance. Posiflex Technology, Inc. shall not be responsible for
any technical support to questions on this aspect. We suggest that you contact
your dealer for OS installation.
7
Operating System Recovery
For the PC-2011/2111 main system preloaded with an operating system,
Posiflex provides a recovery DVD shipped with the main system for the
preloaded operating system. The system integrator shall take care of software
restoration after the OS is recovered.
If you plan to recover your operating system, we do NOT encourage you to
recover any operating system. Please contact your service center for operating
system recovery.
Specifications
PC-2011
PC-2111
System
CPU
Intel Bay Trail J1800
Processor
Intel Apollo Lake N3350
Processor
Memory
DDR3L SO-DIMM x1
Storage
Storage
M.2 2280 connector x 1 (SSD signal only)
OS Support
OS
Windows 10 IoT LTSB
Display & Monitor
LCD Panel
10.1” 1280 x 800 TFT LCD
Touch Panel
P-CAP touch with multi-touch support
Outside I/O Ports
Display Port
VGA x 1 (optional)
Serial Port
RJ50 (RS-232) x 1 (optional)
Ethernet Port
10/100/1000 Mb x 1
Standard USB Port
USB2.0 (external port) x 2 + USB2.0 (internal pin
header) x 2
Audio Port
2W speaker x 1 (optional)
Power Supply
12VDC/40W power adaptor;
Expansion
Expansion Slot
M.2 2230 x 1 for WiFi/BT module
Mechanical
8
PC-2011
PC-2111
Mechanical
VESA mount 75 x 75
Attachment
TA-100
Side attachment with external USB 2.0 port
Environmental
Operating Condition
0°C - 40°C, 20%RH - 90%RH
Storage Condition
-20°C - 70°C, 10%RH - 90%RH
※ The product information and specifications are subject to change without prior notice.
To get the detailed information on PC-2011/2111, please check this model from Posiflex
Global Website (http://www.posiflex.com/en-global/Download/download).
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Posiflex PC-2011/2111 Manuel utilisateur
- Taper
- Manuel utilisateur
- Ce manuel convient également à
dans d''autres langues
- English: Posiflex PC-2011/2111 User manual
Documents connexes
-
Posiflex PC-2111-G2/2111E-G2 Manuel utilisateur
-
-
-
Posiflex PS-3616Q Manuel utilisateur
-
-
Posiflex RT-5115 Manuel utilisateur
-
-
Posiflex RT-6115 Manuel utilisateur
-
-