IMC Networks McPc-Gigabit Mode d'emploi

Marque: IMC Networks

Modèle: McPc-Gigabit

Catégorie: Convertisseurs de média réseau

Taper: Mode d'emploi

McPC-Gigabit

(PCI Version)

Operation Manual

FCC Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a Class B computing device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to

cause harmful interference in which the user will be required to correct the interference at his own expense.

Any changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

The use of non-shielded I/O cables may not guarantee compliance with FCC RFI limits. This digital apparatus does not exceed the Class B

limits for radio noise emission from digital apparatus set out in the Radio Interference Regulation of the Canadian Department of

Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de classe B

prescrites dans le Règlement sur le brouillage radioélectrique publié par le ministère des Communications du Canada.

Warranty

IMC Networks warrants to the original end-user purchaser that this product, EXCLUSIVE OF SOFTWARE, shall be free

from defects in materials and workmanship under normal and proper use in accordance with IMC Networks' instructions

and directions for a period of six (6) years after the original date of purchase. This warranty is subject to the limitations set

forth below.

At its option, IMC Networks will repair or replace at no charge the product which proves to be defective within such

warranty period. This limited warranty shall not apply if the IMC Networks product has been damaged by unreasonable

use, accident, negligence, service or modification by anyone other than an authorized IMC Networks Service Technician

or by any other causes unrelated to defective materials or workmanship. Any replaced or repaired products or parts carry

a ninety (90) day warranty or the remainder of the initial warranty period, whichever is longer.

To receive in-warranty service, the defective product must be received at IMC Networks no later than the end of the

warranty period. The product must be accompanied by proof of purchase, satisfactory to IMC Networks, denoting

product serial number and purchase date, a written description of the defect and a Return Merchandise Authorization

(RMA) number issued by IMC Networks. No products will be accepted by IMC Networks which do not have an RMA

number. For an RMA number, contact IMC Networks at PHONE: (800) 624-1070 (in the U.S and Canada) or (949) 465-

3000 or FAX: (949) 465-3020. The end-user shall return the defective product to IMC Networks, freight, customs and

handling charges prepaid. End-user agrees to accept all liability for loss of or damages to the returned product during

shipment. IMC Networks shall repair or replace the returned product, at its option, and return the repaired or new

product to the end-user, freight prepaid, via method to be determined by IMC Networks. IMC Networks shall not be

liable for any costs of procurement of substitute goods, loss of profits, or any incidental, consequential, and/or special

damages of any kind resulting from a breach of any applicable express or implied warranty, breach of any obligation

arising from breach of warranty, or otherwise with respect to the manufacture and sale of any IMC Networks product,

whether or not IMC Networks has been advised of the possibility of such loss or damage.

EXCEPT FOR THE EXPRESS WARRANTY SET FORTH ABOVE, IMC NETWORKS MAKES NO OTHER WARRANTIES,

WHETHER EXPRESS OR IMPLIED, WITH RESPECT TO THIS IMC NETWORKS PRODUCT, INCLUDING WITHOUT

LIMITATION ANY SOFTWARE ASSOCIATED OR INCLUDED. IMC NETWORKS SHALL DISREGARD AND NOT BE

BOUND BY ANY REPRESENTATIONS OR WARRANTIES MADE BY ANY OTHER PERSON, INCLUDING EMPLOYEES,

DISTRIBUTORS, RESELLERS OR DEALERS OF IMC NETWORKS, WHICH ARE

INCONSISTENT WITH THE WARRANTY SET FORTH ABOVE. ALL IMPLIED WARRANTIES INCLUDING THOSE OF

MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY LIMITED TO THE DURATION OF THE

EXPRESS WARRANTY STATED ABOVE.

Every reasonable effort has been made to ensure that IMC Networks product manuals and promotional materials

accurately describe IMC Networks product specifications and capabilities at the time of publication. However, because of

ongoing improvements and updating of IMC Networks products, IMC Networks cannot guarantee the accuracy of printed

materials after the date of publication and disclaims liability for changes, errors or omissions.

iii

Table of Contents

FCC Radio Frequency Interference Statement ....................................................ii

Warranty............................................................................................................ii

About the McPC-Gigabit ....................................................................................1

Twisted Pair Crossover/Pass-Through Button ......................................................2

LED Indicators....................................................................................................2

Specifications .....................................................................................................2

IMC Networks Technical Support.......................................................................3

Fiber Optic Cleaning Guidelines.........................................................................3

Safety Certifications............................................................................................4

About the McPC-Gigabit

The McPC-Gigabit is a low-cost, IEEE 802.3 single-conversion, PC Card media

converter that converts 1000Base-TX twisted pair to 1000Base-SX multi-mode or

1000Base-LX single-mode fiber. The McPC-Gigabit is available with one RJ-45

connector for the twisted pair port and a SC connector for the fiber port.

The McPC-Gigabit is also available for single-strand which allows two individual

channels to share one strand of fiber; Full-Duplex data travels on different

wavelengths— 1310 nm and 1550 nm.

The McPC-Gigabit can be mounted into any PC with a standard PCI and includes

diagnostic LEDs for each port.

Installing the McPC-Gigabit

Offering plug-and-play operation, the McPC-Gigabit comes ready to install, utilizing

power from the PC’s motherboard. To install the McPC-Gigabit:

Turn off the PC

Remove its cover

Find an empty PCI slot

Align the McPC-Gigabit in the slot

Screw the the McPC-Gigabit into the computer casing’s bracket

Make sure the McPC-Gigabit does not extend past the edge of the case

Attach the keyed mini-power connector to the McPC-Gigabit

Attach the male end of the “Y” connector to one of the computer’s standard size

power connectors

Replace the cover

10.

Attach the cables between the McPC-Gigabit and the devices that will be

connected

Twisted Pair Crossover/Pass-Through Button

Whether you are using crossover or straight-through CAT5 twisted pair cabling,

McPC-Gigabit

will support both types of connections with

AutoCross

, a feature which

automatically selects between a crossover workstation or Pass-Through connection

depending on the connected device.

Link

LED Indicators

Each McPC-Gigabit includes two LEDs, located on the RJ-45 connector.

LED functions are as follows:

FX LNK/ACT Glows green when a link is established on the fiber port; blinks

green when activity is detected on the fiber port.

TX LNK/ACT Glows green when a link is established on the copper port; blinks

amber when activity is detected on the copper port.

Specifications

Environmental

Operating Temperature

32° - 104° F (0° - 40° C)

Storage Temperature

0° - 160° F (-20° - 70° C)

Humidity:

5 - 95% (non-condensing)

Power Consumption (Typical)

Current Draw

0.7A @ 5VDC

Input Specifications

Power Input: 5V

IMC Networks Technical Support

Tel:

(949) 465-3000 or (800) 624-1070 (in the U.S. and Canada);

+32-16-550880 (Europe)

Fax:

(949) 465-3020

E-Mail:

techsupport@imcnetworks.com

Web:

www.imcnetworks.com

Fiber Optic Cleaning Guidelines

Fiber Optic transmitters and receivers are extremely susceptible to contamination by

particles of dirt or dust, which can obstruct the optic path and cause performance

degradation. Good system performance requires clean optics and connector ferrules.

Use fiber patch cords (or connectors, if you terminate your own fiber) only from

a reputable supplier; low-quality components can cause many hard-to-diagnose

problems in an installation.

Dust caps are installed at IMC Networks to ensure factory-clean optical devices.

These protective caps should not be removed until the moment of connecting

the fiber cable to the device. Should it be necessary to disconnect the fiber

device, reinstall the protective dust caps.

Store spare caps in a dust-free environment such as a sealed plastic bag or box

so that when reinstalled they do not introduce any contamination to the optics.

If you suspect that the optics have been contaminated, alternate between

blasting with clean, dry, compressed air and flushing with methanol to remove

particles of dirt.

Safety Certifications

CE: The products described herein comply with the Council Directive on

Electromagnetic Compatibility (89/336/EEC). For further details, contact IMC

Networks.

European Directive 2002/96/EC (WEEE) requires that any equipment that bears this

symbol on product or packaging must not be disposed of with unsorted municipal

waste. This symbol indicates that the equipment should be disposed of separately

from regular household waste. It is the consumer’s responsibility to dispose of this

and all equipment so marked through designated collection facilities appointed by

government or local authorities. Following these steps through proper disposal and

recycling will help prevent potential negative consequences to the environment and

human health. For more detailed information about proper disposal, please contact

local authorities, waste disposal services, or the point of purchase for this equipment.

19772 Pauling • Foothill Ranch, CA 92610-2611 USA

TEL: (949) 465-3000 • FAX: (949) 465-3020

www.imcnetworks.com

The information in this document is subject to change without notice. IMC Networks assumes no responsibility for any

errors that may appear in this document. McPC-Gigabit is a trademark of IMC Networks. Other brands or product names

may be trademarks and are the property of their respective companies.

Document Number 55-80900-00 B0 August 2009

IMC Networks McPc-Gigabit Mode d'emploi

Marque: IMC Networks

Modèle: McPc-Gigabit

Catégorie: Convertisseurs de média réseau

Taper: Mode d'emploi

Télécharger le PDF

rapport

dans d''autres langues

English: IMC Networks McPc-Gigabit Operating instructions

Documents connexes

Autres documents

B&B Electronics McPc-Gigabit Mode d'emploi