Softbank Robotics A00041301 Automatic Cleaning Machine Manuel utilisateur

Taper
Manuel utilisateur
Softbank Robotics corp.
Product Name:
Automatic Cleaning Machine
Model:
A00041301
FCC ID:
2ATI9
-
A00041301
IC ID
-
A00041301
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:
---Reorient or relocate the receiving antenna.
---Increase the separation between the equipment and receiver.
---Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
---Consult the dealer or an experienced radio/TV technician for help.
“Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment”
“This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.”
Softbank Robotics corp.
ISED Compliance
“This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.”
“Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.”
In order to comply with FCC / ISED RF Exposure requirements, this device must
be installed to provide at least 20 cm separation from the human body at all times.
“Afin de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil doit
être installé pour fournir au moins 20 cm de séparation du corps humain en tout
temps.“
  • Page 1 1
  • Page 2 2

Softbank Robotics A00041301 Automatic Cleaning Machine Manuel utilisateur

Taper
Manuel utilisateur