Softbank Robotics P0004930100T soft bank robotics Manuel utilisateur

Marque
Softbank Robotics
Modèle
P0004930100T soft bank robotics
Taper
Manuel utilisateur
Softbank Robotics corp.
Product Name:
Notification Pager Transmitter
Model:
P0004930100T
FCC ID:
2ATI9
-
P0004930100T
IC ID
-
P0004930100T
SAFETY PRECAUTIONS
Please read the safety precautions carefully to ensure the correct use of.
Do not disassemble, modify or repair the device or the battery by yourself,
otherwise the warranty will be invalid.
Do not crush, throw, or puncture your device. Avoid dropping, squeezing, or
bending your device.
Do not use your device in a moist environment.
The operating temperature should be +5℃—+35℃.
Do not expose your device to areas with flammables and explosives.
Do not tum on your device when it is prohibited to use.
For driving safety, the driver cannot operate the device when the car is in motion.
Use a dry soft cloth to clean the device; do not use water, alcohol, detergent or
any chemicals.
Keep the device battery and charger out of the reach of children to prevent them
from swallowing it or injuring themselves by
accident. Children should only use the device with adult supervision.
Observe all rules and regulations applicable to mobile products in hospitals and
health care facilities.
Only use the battery included with the product.
A minimum separation 50mm distance must be maintained between the user’s
body and the device, including the antenna during body-worn operation, to comply
with RF exposure requirements.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
Softbank Robotics corp.
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:
---Reorient or relocate the receiving antenna.
---Increase the separation between the equipment and receiver.
---Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
---Consult the dealer or an experienced radio/TV technician for help.
“Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment”
“This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.”
ISED Compliance
“This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.”
“Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.”
  • Page 1 1
  • Page 2 2

Softbank Robotics P0004930100T soft bank robotics Manuel utilisateur

Marque
Softbank Robotics
Modèle
P0004930100T soft bank robotics
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents