SmartPower SYSTEMS SMART 30 Mode d'emploi

SMART 30
Marque
SmartPower SYSTEMS
Modèle
SMART 30
Taper
Mode d'emploi
USER'S GUIDE
USER'S GUIDE
Thank you for purchasing this Smart30. Smart Power
Systems is dedicated to developing and manufacturing
the highest performance power protection and filtration
devices for your electronic equipment. Proper use of this
device will provide the protection needed for your
connected equipment.
P.N.16001090 Rev.05/22
30 AMPS
30 AMPS
Smart30
3-PHASE
SINGLE PHASE
L21-30PL21-30R
L15-30PL15-30R
L14-30PL14-30R
L6-30PL6-30R
L5-30P
L5-30R
Use this user's guide for the following products:
MODEL
DESCRIPTION
CAUTION
ATTENTION
ATTENTION
ATTENTION
CAUTION
CAUTION
• Use only in dry locations indoors.
• Avoid dropping the unit.
• Only plug the Smart30 into a three pronged grounded outlet. This unit is not to be
used with any type of ground “lift” or pin eliminator.
• Do not open the Smart30 unit, there are no serviceable parts inside. Opening the unit
will void your warranty.
This device features an internal protection that will disconnect the surge protective component
at the end of its useful life but will maintain power to the load now unprotected. If this situation
is undesirable for the application, follow the manufacturer's instructions for replacing the device.
Do not install this device if there is not at least 10 meters (30 feet) or more of wire between the
electrical outlet and the electrical service panel.
S30-1P240
S30-1P120-240
S30-3P240
S30-3P120-208
S30-1P120
30 Amp, Single Phase 120/240 Volts, 3 wire + Ground
30 Amp, 3 phase 240 Volts, 3 wire + Ground
30 Amp, 3 phase 120/208 Volts, 4 wire + Ground
30 Amp, Single Phase 120 Volts, 2 wire + Ground
30 Amp, Single Phase 240 Volts, 2 wire + Ground
OUTPUT
RECEPTACLE
OUTPUT
RECEPTACLE
OUTPUT
RECEPTACLE
OUTPUT
RECEPTACLE
OUTPUT
RECEPTACLE
PLUG
TYPE
PLUG
TYPE
PLUG
TYPE
PLUG
TYPE
PLUG
TYPE
• Utiliser uniquement dans des endroits secs à l'intérieur.
• Évitez de faire tomber l'appareil.
• Ne branchez le Smart30 dans une prise de terre à trois pronged. Cette unité ne doit pas être
utilisé avec tout type de terrain "ascenseur" ou broches éliminateur.
• Ne pas ouvrir l'unité Smart30, il n'y a pas de pièces réparables. Ouverture de l'unité annulera
votre garantie.
Cet appareil dispose d'une protection interne qui va déconnecter le composant de protection
contre les surtensions à la fin de sa vie utile mais se maintenir au pouvoir à la charge maintenant
sans protection. Si cette situation est souhaitable pour l'application, suivez les instructions du
fabricant pour le remplacement de l'appareil.
Ne pas installer cet appareil si il n'y a pas au moins 10 mètres (30 pieds) ou plus de fil entre la
prise électrique et le panneau de service électrique.
1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the Smart30 Unit.
3. Plug the Smart30 unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the Smart30 where monitoring lights can
be observed.
INSTALLATION OF SMART30
WALL MOUNT INSTALLATION
Connected
Equipment
Power Cord
Power Cord
ATTENTION
CAUTION
In case of reverse phase sequence in 3 phase models (RED LED ON), the phase sequence should
be corrected at the wall outlet by a certified electrician. Reverse phase sequence might lead to
malfunction of the 3 phase equipment.
If you have any questions call us at our Tech Support line toll free
1-800-772-7633 or email us at [email protected]
OUTPUT RECEPTACLE
OUTPUT
RECEPTACLE
INPUT PLUG
WITH CORD
INPUT PLUG WITH CORD
PHASE SEQUENCE INDICATORS
NORMAL REVERSE LINE 1 LINE 2 LINE 3
LINE 3
LINE 1
NORMAL
REVERSE
LINE 2
PHASE
SEQUENCE
INDICATORS
POWER LINE INDICATORS
Smart30
ON
FAULT
FRONT VIEW
REAR VIEW
FRONT VIEW
REAR VIEW
3-PHASE
3-PHASE
SINGLE PHASE
SINGLE PHASE
BACK OF UNIT
To mount your Smart30 unit to a wall or
other surface, first, install four screws (not
included) on the wall, where monitoring
lights can be observed. Leave 1/4 inch of
the screw exposed. Use the two mounting
holes in the back of the Smart30 by sliding
them into the exposed part of the screws
and lock into place.
En cas de séquence de phase inverse en 3 modèles de phase (LED rouge sur), la séquence de
phase devrait être corrigé à la prise murale par un électricien certifié. Séquence de phase inverse
peut entraîner un dysfonctionnement de l'équipement en 3 phases.
Meets
UL 1449 3rd. Edition
Requirements
7409 Railhead Ln. - Houston, Texas 77086 - Tel:(713)464-8000 - Fax:(713)984-0841
E-mail: [email protected] - www.smartpowersystems.com
IMPORTANT
If for any reason you need to return the Smart30 unit to the manufacturer, you should
obtain an RMA (Return Material Authorization) number before returning the unit. To
request an RMA number please call 1-800-772-7633 or visit the website at
www.smartpowersystems.com/rma.htm
UNINTERRUPTIBLE POWER SUPPLIES - UPS SERIES
Smart Power Systems' Uninterruptible Power Supplies (UPS) integrated TBF™ Technology
provide on-line power conditioning.
OTHER POWER PROTECTION PRODUCTS
WARRANTY
All Smart30 units are guaranteed free of defects in material or workmanship for 5 years. See our
website for more details - www.smartpowersystems.com
TRANSFORMER BASED FILTER SERIES (TBF™) POWER FILTERS
Considered to be one of the most significant developments in the power protection industry.
TBF™ Filters contain innovative technology that combines Surge Suppression and Noise
Isolation which filters the noise on the ground to less than 0.5 Volts (US Patent # 6229682).
Exclusive "POVP" Prolonged Over Voltage Protector (US Patent # 6560086) disconnects the
output power if voltage exceeds 155 volts. Exclusive Smart Technology (US Patent
#5721661) protects microprocessor based equipment against reverse polarity or no ground.
The patented TBF™ filters prevent 90% of the power problems experienced by your POS
system, computer, copier and facsimile machine.
If the Smart Power Systems equipment fails and this failure allows a surge to pass through and
damage the connected equipment, Smart Power Systems will pay for the repair or replacement of
the connected equipment of the original purchaser . Please take the time to register each Smart
Power Systems' product along with the connected equipment devices connected to it within 10
days of date of purchase in order for you to take advantage of this product warranty and connected
equipment protection policy. See our website for more details - www.smartpowersystems.com
$25,000 Connected Equipment Warranty
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

SmartPower SYSTEMS SMART 30 Mode d'emploi

SMART 30
Marque
SmartPower SYSTEMS
Modèle
SMART 30
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents