This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
The device has been evaluated to meet general RF exposure requirement. To maintain compliance with RSS102 —
Radio Frequency (RF) Exposure guidelines,
this equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement
Cet équipement est conforme aux limites d'exposition de rayonnement d'IC RSS-102 déterminées pour un
environnement non contrôlé. Cet équipement devrait être installé et actionné avec la distance minimum 20 cm entre le
radiateur et votre corps.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
10. Only use attachments/accessories specified by the manufacturer.
11. Unplug this apparatus during lightning storms or when unused for long periods of time.
12. Refer all servicing to qualified personnel. Servicing is required when the apparatus has been damaged in any way,
such as external power supply, power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
13. To reduce the risk of fire or electrical shock, do NOT expose this product to rain, liquids or moisture.
14. Do NOT expose this product to dripping or splashing, and do not place objects filled with liquids, such as vases, on
or near the product.
15. Keep the product away from fire and heat sources. Do NOT place naked flame sources, such as lighted candles, on
or near the product.
16. Do NOT make unauthorized alterations to this product.
17. Do NOT use in vehicles or boats.
18. Use this product only with the power supply provided.
19. Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain
readily operable.
20. Due to ventilation requirements, does not recommend placing the product in a confined space such as in a wall
cavity or in an enclosed cabinet.
21. Do not place or install the bracket or product near any heat sources, such as fireplaces, radiators, heat registers or
other apparatus (including amplifiers) that produce heat.
22. The product label is located on the bottom of the product.
Regulatory Information Important Safety Instructions
IMPORTANT, RETAIN FOR FUTURE REFERENCE:
READ CAREFULLY | SAVE THESE INSTRUCTIONS
Desk Lamp with Wireless Chrarger:
Component: UTL1006
Input: 9V⎓, 2.5A
Output (Wireless): Qi (10W / 7.5W / 5W)
Output (USB-A): 5V⎓, 2A, 10W Max
White Light: 8W 0-650 lumens Max, 2800-6500 Kelvin
RGB Light: 1W, 6 color selections
Dimensions: 366 x 160 x 332 mm (14.4 x 6.3 x 13.1 in.)
Weight: 800 g (1.8 lb.)
Wall Adapter:
Model: AS024-0902500U
Input: AC 100-240V, 50/60 Hz
Output: 22.5W, 9V⎓2.5A
Dimensions: 71 x 44 x 52 mm (2.8 x 1.7 x 2.0 in)
Weight: 130 g (4.6 oz)
Features
with Wireless Charger
User Manual and
Safety Instructions
illumia
LED Desk Lamp
Technical Specifications
Your wireless charging lamp is designed to provide optimal charging for your wireless device:
Motorola, LG
5.25 ft. Cable
White Temperature
Cycle through
warm/natural/cool
Lamp Power
Press and hold for
dimming
RGB Night Lamp
Press and hold to
cycle through
6 colors
Power and wireless
charging indicator
Note: Periodic tightening
of the elastic bolt hinge
may be necessary,
please use the included
key to tighten.
Some smaller devices
may not align with the
lamp’s charging coil, use
the provided silicone ring
to raise the phone.
Plug in Lamp Charge devices
MODEL: IDL100/IDL100E
Touch controls
Warranty
At Ubio Labs, we are dedicated to designing and manufacturing products with
superior performance and 100% customer satisfaction. All of our products come with
a 1-year limited warranty from date of purchase.
We are always improving our products’ features and functionality. We reserve the
right to change product specifications at any time without notice.
Thank you for your purchase!
www.ubiolabs.com | support@ubiolabs.com
1-866-642-4428 (Monday - Friday 9am - 4:30pm PST)
Ubio Labs, Inc. | 2821 Northup Way, Suite 250 Bellevue, WA 98004
DO NOT RETURN TO THE STORE
Our customer service team is here to help.
Tips and Tricks
-
1
dans d''autres langues
- English: ubiolabs illumia User manual
Documents connexes
Autres documents
-
Lightspeed Mobile PA Manuel utilisateur
-
Lightspeed Topcat Manuel utilisateur
-
-
iHome iW18 Bedside/Office Clock Manuel utilisateur
-
iHome iW18 Bedside/Office Clock Mode d'emploi
-
Dynaudio Xeo 10 Le manuel du propriétaire
-
Lightspeed 975 Manuel utilisateur
-
VOCOlinc DL2202 Manuel utilisateur
