10.3 Change a programme
1. Turn the Programme knob to OFF
2. Set the programme.
10.4 At the end of the
programme
When the programme is completed:
• An intermittent acoustic signal
operates.
• The indicators End/Anticrease (End/
Anticrease) , Filter and Tank
comes on.
• The Start/Pause indicator is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed or completed.
When the crease guard phase is
completed:
• The indicators End/Anticrease End/
Anticrease ,
Filter and Tank
comes on.
• Start/Pause indicator goes off.
1. Turn the Programme knob to OFF
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter and
empty the water container
when a programme is
completed.
10.5 Stand-by function
To decrease the energy consumption, this
function automatically deactivates the
appliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the
programme.
10.6 Indicator lights
These lights indicate the following
functions:
• Drying (Drying) : This light indicates
that the appliance is in the drying
phase.
• Cooling (Cooling): This light indicates
that the appliance is in the cooling
phase.
• End/Anticrease (End/Anticrease) :
This light indicates that the appliance is
in the anticreasing phase and at the
end of the programme.
• Condenser
: This light indicate that
the condenser must be cleaned.
• Filter
: This light illuminates at the
end of the programme to remind you
that the filters must be cleaned.
• Tank : This light comes on at the
end of the programme to remind you
that the water reservoir must be
emptied out. This light comes on also
when the water reservoir is not inserted
correctly.
11. HINTS AND TIPS
11.1 Preparing the laundry
• Close the zippers.
• Close the fasteners of the duvet
covers.
• Do not keep ties or ribbons loose (e.g.
apron ribbons). Tie them before you
start a programme.
• Remove all items from the pockets.
• If an item has the internal layer made of
cotton, turn it inside out. Make sure
that the cotton layer is always external
• We recommend that you set the
correct programme applicable for the
type of fabrics that are in the appliance.
• Do not put fabrics with strong colours
together with fabrics with light colours.
Strong colours can bleed.
www.electrolux.com12