Verkada Inc. 406 E 3rd Ave, San Mateo, CA 94401
All specifications are subject to change without notice
Copyright © 2023 Verkada Inc. All rights reserved.
1
Technical Support
If you encounter problems when installing or
using this product, please consult the Verkada
website at https://www.verkada.com/support/
Installation
1. Before attaching the Ethernet cable to injector and equipment, please unplug the injector from
the AC power and verify that the output voltage and output current of the unit is suitable for and
within the rating of the equipment.
2. Keep the linkage between the injector and its power cord tight, as well as connecting the Ethernet
cable to the equipment properly.
3. Protect the power cord and input line against mechanical stress.
4. Ensure good ventilation for the unit during use to prevent it from overheating. A 10-15cm clearance
from other heat sources must maintained.
5. An approved power cord should be greater than or equal to SVT/SPT or H03VV-F.
6. If the end equipment is not used for a long period of time, disconnect the equipment from the
injector to avoid being damaged by voltage peaks or lightning strikes.
Caution 1. Risk of electrical shock and energy hazards. All failures should be examined by a qualified
technician. Please do not remove the case of the adapter and try to fix the issue yourself.
2. Risk of fire or electrical shock. The openings should be protected from foreign objects or
dripping liquids.
3. Injectors should be placed or mounted on a reliable surface. A drop or fall could cause
damage.
4. Do not put injectors in places in a damp environment or near/in the water.
5. Do not put injectors in places with high ambient temperature or near/in a heat source.
6. Output current and output wattage must not exceed the rated values on datasheets.
7. Disconnect the unit from the AC power before cleaning. Only use a slightly damp cloth to
wipe the product.
8. Do not use any liquid detergents or aerosol cleaners.
9. Please contact your local qualified recycler when you want to dispose the product.
10. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
11. This device may not cause harmful interference.
12. This device must accept any interference received, including interference that may cause
undesired operation.
North America: +1 (650) 514-2500
Latin America: +52 (5) 565991555
Europe: +44 (0) 20 3048 6050
Asia / Pacific: +61 (1800) 718550
Install Guide
INJ-POE-PLUS Gigabit PoE+ Injector