5019 100 75070
LSE 2545 - 2745
1.
Control panel
2.
Grease filter
3.
Lighting unit
4.
Grease filter surround
REMOVING AND WASHING THE
GREASE FILTER - Fig. 1
1.
Unplug the appliance or switch off the mains
power supply.
2.
Removing the dirty grease filter:
- pull(
a
) the handles out and (
b
) towards the
centre.
3.
After cleaning the grease filter remount in
reverse order, making sure the entire
extraction surface is covered.
FITTING OR REPLACING THE CARBON
FILTER - Fig. 2
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove the grease filter (
a, b - Fig. 1
).
3. Fitting:
mount the carbon filter by sliding it
OVER the metal tabs (
c
) and fitting it into
locations (
d
) using carbon filter buttons (
e
).
Removing:
press the carbon filter release
buttons (
e
), pulling the filter downwards and
outwards.
4.
Remount the grease filter.
REPLACING BULBS - Fig. 2
1.
Unplug the appliance or switch off the mains
power supply.
2.
Open the lighting unit, turn the side knobs on
the unit anticlockwise (
f
).
3.
Remove the burn-out bulb.
Model LSE 2545:
use only PL 11W max. bulbs
Model LSE 2745:
use only PL 9W max. bulbs.
4.
Close the lighting unit.
CONTROL PANEL
A.
ON/OFF light switch.
B.
Speed selector
1
4
2
3
O
Fig. 2
Fig. 1
e
d
ff
small amount of steam and fumes
medium amount of steam and fumes
large amount of steam and fumes
intensive speed
large amount of steam and fumes
e e
cc
b
a
PRODUCT DESCRIPTION SHEET
F NL E PGBD GRI