AKB 397
5019 100 75059
INSTALLATIONSANGABEN
Mindestabstand zur Kochfläche: 65 cm (Elektroplatten), 75 cm (Gas-, Öl-,
Kohlekochplatten)
INSTALLATION SHEET
Minimum height above cooker: 65 cm (electric cookers), 75 cm (gas, gas oil
or coal cookers)
FICHE D'INSTALLATION
Distance minimale par rapport à la cuisinière : 65 cm (cuisinière électrique),
75 cm (cuisinière à gaz, mazout ou charbon)
INSTALLATIESCHEMA
Min. afstand van het kooktoestel: 65 cm (elektrische kooktoestellen), 75 cm
(kooktoestellen op gas, olie of kolen)
FICHA DE INSTALACIÓN
Distancia mínima desde los quemadores: 65 cm (quemadores eléctricos),
75 cm (quemadores a gas, gasóleo o carbón)
FICHA DE INSTALAÇÃO
Distância mínima do fogão: 65 cm. (fogões eléctricos), 75 cm. (fogões a gás,
óleo ou carbono)
SCHEDA INSTALLAZIONE
Distanza minima dai fuochi: 65 cm (fuochi elettrici), 75 cm (fuochi a gas,
gasolio o carbone)
ù(ù ü+ù$ùþ
ü$12.)12.1.)2"0120" FP02!"0120" FP0120"
.0! #02!0. #0! #.
D
GB
F
NL
E
P
I
*5
5019 100 75059
AKB 397
5
5
4
4
292
515
1
2
3
6
9
9
7
10
8
8
8
8
A
8: Die Schrauben der
Befestigungsfedern am
Hängemöbel fest anziehen.
8: Tighten the screws of the
fixing clips to the wall unit.
8: Serrez les vis des ressorts
de fixation sur l'élément
mural.
8: Draai de schroeven van de
bevestigingsveren aan het
keukenkastje.
8: Apretar los tornillos de los
muelles de fijación del
mueble colgante.
8: Aperte os parafusos das
molas de fixação no móvel.
8: Serrare le viti delle molle di
fissaggio al pensile.
8:
3202"/0"2&
0.2!&120!&1"12
2 #
5019 100 75059
AKB 397
1.
Control panel.
2.
Grease filter (inside the extractor grille).
3.
Extractor grille fixing screws.
4.
Lighting unit.
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove the extractor grille and unscrew the
fixing screws to access the grease filter.
3.
Remove the device fixing the grease filter.
4.
Remove the dirty grease filter.
5.
After replacing or cleaning the grease filter
(depends on model), remount in reverse
order, making sure the entire extraction
surface is covered.
REPLACING BULBS
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove the extractor grille and unscrew the
fixing screws to access the bulbs.
3.
Remove the burnt-out bulb.
Use 40W max E14 bulbs only.
4.
Remount the extractor grille.
FITTING OR RENEWING THE CARBON
FILTER
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove the extractor grille and unscrew the
fixing screws to access the carbon filter (or
the carbon filter location).
3. Fitting:
Cut off the plastic tab (
c
). Fit the
carbon filter over the motor protection grille -
the reference mark (
a
) on the edge of the
carbon filter should line up with the arrow on
the fan shroud (
b
). Turn clockwise.
Removing:
turn anti-clockwise.
4.
Remount the extractor grille.
CONTROL PANEL
A.
Speed selector.
B.
Light switch.
2
3
1
3
4 4
a
b
c
AB
small amount of steam and fumes
large amount of steam and fumes
a
PRODUCT DESCRIPTION SHEET
F NL E PGBD GRI
-
1
-
2
-
3
