8Aruba USB LTE Modem | Installation Guide
Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
EU & UK Regulatory Conformity
The Declaration of Conformity made under Radio Equipment Directive 2014/53/EU as well as the United Kingdom's Radio
Equipment Regulations 2017/UK is available for viewing below. Select the document that corresponds to your device’s model
number as it is indicated on the product label.
EU & UKDeclaration of Conformity
Japan VCCI
This is a Class B product. In a domestic environment this product may cause radio interference in which case the user may be
required to take corrective actions.
Waste of Electrical and Electronic Equipment
Aruba products at end of life are subject to separate collection and treatment in the EU Member States, Norway, and Switzerland
and therefore are marked with the symbol shown at the left (crossed-out wheelie bin). The treatment applied at end of life of
these products in these countries shall comply with the applicable national laws of countries implementing Directive 2012/19/EU
on Waste of Electrical and Electronic Equipment (WEEE).
India RoHS
This product complies with RoHS requirements as prescribed by E-Waste (Management & Handling) Rules, governed by the
Ministry of Environment & Forests, Government of India.
Taiwan
ῶᑡ㟁☢Ἴᙳ㡪䠈ㄳጇ㐺⏝
RF Radiation Exposure Statement: This equipment complies with RF radiation exposure limits. This equipment
should be installed and operated with a minimum distance of 7.874 inches (20cm) between the radiator and
your body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Déclaration sur les limites d'exposition aux radiofréquences : cet équipement est conforme aux limites
d'exposition aux rayonnements radioélectriques spécifiées. Il doit être installé et utilisé à une distance minimale
de 20 cm. Cet émetteur-récepteur ne doit pas être utilisé ou situé à proximité d'autres antennes ou émetteurs-
récepteurs.