Britax B-Clever Mode d'emploi

B-CLEVER

TM

Stroller

User Guide

Guide de l’utilisateur

Guía del usuario

1

B-CLEVER

TM

and BRITAX

®

are trademarks owned by Britax Child Safety, Inc. All

subject to change without notice. P11880400_A:06.19

Contents

Safety Information ��2

Features ��4

In The Box ��5

Assembly ��6

Stroller Frame .....................................................................................6

Front Wheel ........................................................................................ 6

Rear Wheels ....................................................................................... 7

Canopy ...............................................................................................8

Cup holder ......................................................................................... 9

Operation ��10

Using the Stroller .............................................................................10

Adjusting the Seat ............................................................................ 11

Using the Parking Brake ..................................................................12

Using the Front Wheel Swivel Lock .................................................12

Using the Harness ........................................................................... 12

Securing Your Child ��14

Infant Car Seat Mode ��15

Using the Infant Car Seat Receivers ................................................15

Using a Britax Infant Car Seat .........................................................17

Care and Maintenance ��18

Warranty ��19

2

Safety Information

Failure to follow all warnings and instructions

could result in SERIOUS INJURY or DEATH.

Read these instructions carefully before using this product�

To ensure proper use, store this user guide in a convenient

place so it can be consulted often�

• Never leave child unattended.

• Do not use stroller with a child taller than 44 inches (111.8 cm).

• Do not use stroller with a child who weighs more than 50 lbs

(22.6 kg). Exceeding this limit may cause stroller to become

unstable.

• Avoid serious injury from falling or sliding out. Always use

harness to secure child.

• Avoid finger entrapment or injury. Always ensure any child

occupants or bystanders are away from the stroller while

folding or unfolding.

• Stroller appropriate from birth, however, Britax recommends

use only with an infant car seat until child has head and neck

control.

• Do not overload basket – Maximum weight in basket is 10

lbs (4.5 kg). Overloading the basket may cause the stroller to

become unstable and tip over.

• Do not overload the hood storage pocket - Maximum weight

in storage pockets is 1 lb (0.45 kg) per pocket. Overloading the

storage pocket may cause the stroller to become unstable and

tip over.

• DO NOT overload cup holder. Maximum weight -16 ounces

(0.5 kg).

3

• Do not attach parcels, bags, or other items to the handlebar

or frame of stroller except those recommended by Britax, as

stroller can become unstable and tip over.

• Always make certain that the stroller is fully open and locked

before use.

• Assembly of this stroller must be performed only by an adult.

• Only use Britax approved car seats, accessories and

replacement parts with this stroller.

• Do not allow children to climb on or play with the stroller.

• Do not use the stroller on stairs, escalators, moving vehicles, or

steep inclines. Stroller can tip over.

• Stroller is intended for walking speed only. Do not use while

jogging, skating, or any activity other than walking.

• Always set the parking brake when stroller is not moving. Never

load or unload the stroller without the parking brake set.

• Do not park on inclines. The parking brake is intended to park

the stroller on flat surfaces only. Parking on inclines may result

in tip over or runaway stroller.

• Do not exceed the manufacturer’s maximum weight limit

when using an infant car seat with this product. See infant

car seat user guide for maximum occupant weight and other

instructions.

• All infant car seats MUST be installed rear facing.

• Do not modify the stroller or any labels. Doing so voids the

warranty and could lead to a dangerous condition.

• Failure to regularly inspect this product and its components to

make sure they are in good condition and good working order

can result in injury. Discontinue use of stroller if damaged or

any parts are missing.

4

Actual product may vary from images.

Features

Canopy

Handle

Chassis

Lock

Harness

& Buckle

Front Wheels

Rear Wheel

Release

Button

Frame

Release

Button

Frame

Release

Strap

Under-

Seat

Storage

Basket

Swivel

Lock

Rear

Wheel

5

Actual product may vary from images.

In The Box

B-Clever Stroller

Canopy

Infant Car Seat Receivers

Cup Holder

(in select models)

Front Wheels

Rear Wheels

6

Assembly

Stroller Frame

1. Push the release on the chassis lock

and open the frame.

2. Lift handle until frame locks into upright

position.

NOTE: After stroller is upright, push

down on handle to make sure frame is

locked in open position.

Front Wheels

Installing the Front Wheels

1. Slide the front wheel assembly

onto the mounting post at the

front of the stroller.

2. Pull wheel to ensure that it is secure.

7

Removing the Front Wheels

1. Pull the release lever at the back of the

mounting post and pull the wheel away

from the stroller.

Rear Wheels

Installing the Real Wheels

1. Slide the rear wheel axle into the rear

wheel hub mounting bracket until it

locks into place.

2. Pull wheel to ensure that it is secure.

Removing the Rear Wheels

1. Pull and hold the release lever

at the bottom of the rear wheel hub

while pulling the rear wheel away

from the stroller.

8

Canopy

1. Slide the canopy stay brackets into the

stroller frame mounts until they lock

into place.

2. Attach the hook and loop fasteners on

the hood of the stroller.

3. Attach the hook and loop fasteners

around the outer edge of the canopy

and hood to the stroller.

9

Cupholder (in select models only)

1. To install, push cup holder bracket onto

the holding pin located on the side of

the stroller handle. A click will confirm it

is secure.

2. To remove, pull out the cup holder off

the holding pin. You will hear a click.

10

Operation

Using the Stroller

Folding the Stroller

IMPORTANT:

Always apply brake and

remove children before folding

the stroller.

1. Press the frame release button once.

NOTE: Not necessary to continue to

hold the button.

2. Locate the frame release strap under

the seat cover in the middle of the seat.

3. Pull the strap until the stroller collapses

and locks. Check to make sure the

chassis lock is secure.

IMPORTANT:

• Before and during use, always make sure the child’s hands and feet are away

from wheels.

• Protect stroller when transporting and shipping to prevent damage to stroller and

stroller components. Check closely for damage after transporting and shipping.

11

Unfolding the Stroller

1. Push the release on the chassis lock

and open the frame.

2. Lift the handle until frame locks into

upright position.

NOTE: After stroller is upright, push

down on handle to make sure frame is

locked in open position.

Adjusting the Seat

1. To recline, pull the recline adjuster

release lever and slide it away from

the seat.

2. To raise, pull both straps apart.

CLICK

12

Using the Parking Brake

1. Press the brake pedal down to

lock the brake.

NOTE: Pressing the brake locks both

back wheels.

2. Lift the brake pedal to release

the brake.

Using the Front Wheel Swivel Lock

1. Press the swivel lock lever down

to lock the front wheel.

2. Lift the swivel lock lever to allow the

wheel to swivel.

Using the Harness

IMPORTANT: Shoulder and waist straps separate for care and

maintenance, but should always be used together to secure

your child.

1. Align the tongues on the waist straps

with the retainers of the shoulder

straps and slide through until they lock

into place.

2. Insert the tongues into the buckle

assembly until a click is heard.

CLICK

13

Adjusting the Harness

IMPORTANT: The harness can be adjusted to three dierent heights.

Always ensure proper adjustment at or above your child’s shoulders.

1. Pull the harness strap retainer

away from the seat back and turn

90 degrees to feed it through the

harness slot.

2. Push the harness retainer through the

appropriate harness slot to the back

of the seat.Turn the harness retainer

to its original position as shown so it

properly retains the harness.

3. Turn the harness retainer to its original

position as shown so it properly retains

the harness.

14

Securing Your Child

1. Release the harness by depressing the

button in the center of the buckle while

pulling the two tongues away from the

buckle assembly.

2. Fasten the harness by inserting the

tongues on the harness straps into the

buckle assembly.

3. Tighten or loosen the harness straps by

sliding the harness adjusters.

15

Infant Car Seat Mode

• All infant car seats MUST be installed rear facing.

• Always remove the infant car seat receivers when not in use.

Failure to do so may result in injury.

IMPORTANT:

• For infant car seats compatibility refer to us.britax.com/faqs/.

• Always secure child in harness when infant car seat is in use with

the stroller.

Using the Infant Car Seat Receivers

Attaching the Infant Car Seat Receivers

NOTE: Attach the adapters as shown in the image.

1. Lock the parking brake.

2. Align the receiver with the mount on

the inside frame of the stroller, then

push down until a click is heard.

Pull up on the receiver to ensure it is

secure.

3. Repeat for the other side.

CLICK

16

CLICK

Removing the Infant Car Seat Receivers

1. Press the button on the receiver

and slide upward.

2. Repeat for the other side.

17

Using a Britax Infant Car Seat

Attaching a Britax Infant Car Seat

1. Set the parking brake.

2. Line up the adapter on the infant car

seat with the receivers on the stroller.

3. Press down until locked into place.

4. Lift up on both sides of the infant car

seat to ensure that it is secure.

Removing a Britax Infant Car Seat

Refer to your infant car seat user guide for information on the removal

instructions for your speciﬁc model.

18

IMPORTANT: Before each use, check the stroller and its

components to make sure they are in good condition and good

working order.

Parking Brake

• Periodically check that the parking brake works

properly and locks both wheels securely.

• Clean out any dirt or debris that may prevent the

brake from working.

Frame • Wipe the frame with a damp cloth and mild

soap. Use clean, dry cloth or towel to wipe

away excess water and soap.

Fabric and

Harness

• Do not machine wash or dry the cover.

• Hand wash with cold water and mild soap. Air

dry to prevent shrinking.

• Do not iron.

Plastic Parts

• Wipe with a damp cloth and mild soap. Use a

clean, dry cloth or towel to wipe away excess

water and soap.

• Do not use abrasives, solvents, strong

detergents, or household cleaners. These

products can scratch, discolor, and weaken

plastic or cause corrosion on metal surfaces.

Maintenance • If the stroller gets wet, wipe with a clean cloth

or towel to prevent corrosion.

• Do not fold the stroller when wet or damp.

Always make sure that the stroller is dry

before storing.

Storage • To prevent damage to plastic parts, store away

from extreme heat.

• Cover the stroller to prevent dust build-up and

exposure to sunlight.

• Do not stack other items on top of the stroller.

Care and Maintenance

La page charge ...

Britax B-Clever Mode d'emploi

Ce manuel convient également à

Britax B-Clever Mode d'emploi

dans d''autres langues

Documents connexes

Autres documents