UNITUNE CLIP
Clip-On Tuner with Strobe and
Chromatic Modes and 108 LED Matrix Display
for Uncompromised Tuning Quality
Quick Start Guide
(1)
POWER button turns Unitune Clip on and o . Unitune Clip
turns o automatically after 5 minutes.
(2)
REFERENCE TONE button can be used to adjust the reference
pitch used for tuning up or down from the default setting (A =
440 Hz). See “Changing the Reference Pitch” for instructions.
(3)
DISPLAY MODE button toggles between Needle and Strobe
tuning modes.
(4)
ADAPTIVE DISPLAY ORIENTATION INDICATORS show the
current display direction. The display will automatically ip to
stay oriented for viewing at all times.
(5)
MAIN DISPLAY shows the individual pitch of the currently-
tuned string in Needle/Strobe Tuning Mode.
(6)
SECONDARY DISPLAY shows the detected note name for the
currently-tuned string.
Visit tcelectronic.com to download the full manual
(5)
(4)
(3)
(2) (1)
(6)
Needle Mode
In Needle Mode, a single string’s pitch is indicated by a column of ve
LEDs in the MAIN DISPLAY, and the target pitch’s name appears in the
SECONDARY DISPLAY.
Tune the string until the column of LEDs are centered and “on target”
(left = at; right = sharp).
Strobe Mode
In Strobe Mode, a single string’s pitch has two indicators:
• Red LEDS to the left ( at) or right (sharp)
of the center LED column
• “Rotating” segments in the display
Tune the string until the rotating segments slow down and stop,
and only the center column of LEDs lights up.
Changing Reference Pitch
The default reference pitch (A = 440 Hz) can be changed by following
these steps:
1. Press REFERENCE TONE button. The display will show the
current reference pitch (e.g., “440” for 440 Hz).
2. To increase the reference pitch in 1 Hz steps, press the
REFERENCE TONE button.
3. To decrease the reference pitch in 1 Hz steps, press the DISPLAY
MODE button.
4. To store the currently-displayed reference pitch, refrain from
pressing either button for 2 seconds. The set reference pitch
will blink 3 times.
Speci cations
Type Chromatic strobe tuner, clip-on
Tuning range A0 (27.5 Hz) to C8 (4186 Hz)
Tuning accuracy Chromatic tuning mode: ±0.5 cent
Strobe tuning mode: ±0.02 cent
Reference pitch A4 = 435 to 445 Hz,
adjustable in 1 Hz steps
Battery CR2032 Li-Mn battery (included)
Dimensions 28 x 25 x 60 mm (1.1 x .98 x 2.36")
Weight 32 g (1.13 oz), including battery
LEGAL DISCLAIMER
Music Tribe accepts no liability for any loss which may be su ered by
any person who relies either wholly or in part upon any description,
photograph, or statement contained herein. Technical speci cations,
appearances and other information are subject to change without
notice. All trademarks are the property of their respective owners.
Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy, Turbosound,
TC Electronic, TC Helicon, Behringer, Bugera, Aurotone and Coolaudio are
trademarks or registered trademarks of Music Tribe Global Brands Ltd.
© Music Tribe Global Brands Ltd. 2019 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional
information regarding Music Tribe’s Limited Warranty, please see
complete details online at musictribe.com/warranty.
Zhongshan Eurotec Electronics Limited
No. 10 Wanmei Road, South China Modern Chinese Medicine Park,
Nanlang Town, 528451, Zhongshan City, Guangdong Province, China
! WARNING – Coin/Button Cell Battery
• DO NOT INGEST BATTERY! CHEMICAL BURN HAZARD!
• This product contains a coin/button cell battery. If the coin/button
cell battery is swallowed, it can cause severe internal burns in just
2 hours and can lead to death.
• Keep new and used batteries away from children. If the battery
compartment does not close securely, stop using the product and
keep it away from children.
• If you think batteries might have been swallowed and placed
inside any part of the body, seek immediate medical attention.
• CAUTION: Danger of explosion if battery is incorrectly
replaced! Replace only with the same or equivalent type!
! AVERTISSEMENT - Pile bouton / pile
• NE PAS INGÉRER LA BATTERIE! DANGER DE BRÛLURE
CHIMIQUE!
• Ce produit contient une pile bouton / pièce. En cas d'ingestion de
la pile bouton, elle peut provoquer de graves brûlures internes en
seulement 2 heures et entraîner la mort.
• Gardez les piles neuves et usagées hors de la portée des enfants.
Si le compartiment de la batterie ne se ferme pas correctement,
arrêtez d'utiliser le produit et éloignez-le des enfants.
• Si vous pensez que les piles ont pu être avalées et placées dans
n’importe quelle partie du corps, consultez immédiatement
un médecin.
• ATTENTION: Danger d'explosion si la batterie est
remplacée de manière incorrecte! Remplacez uniquement
par le même type ou un type équivalent!
! WARNING: Depending on various factors such as age-related
changes or the surface nish, there is a possibility that your instrument’s
coating may be damaged by attaching this product. In general, do not
leave accessories such as Unitune Clip attached to your guitar longer
than necessary, as the rubber pad may adversely a ect the nish of
your instrument, especially when it is exposed to sunlight for extended
periods of time.
FEDERAL COMMUNICATIONS COMMISSION
COMPLIANCE INFORMATION
SUPPLIER’S DECLARATION OF
CONFORMITY (SDoC)
Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 5270 Procyon Street
Las Vegas, NV 89118
Phone Number: +1 702 800 8290
UNITUNE CLIP
This equipment has been tested and found to comply with the limits for a ClassB
digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit di erent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Caution!
Any changes or modi cations not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Music Tribe Brands UK Ltd.,
Quay House,City Park Business Village,5 Brindley Road, Manchester,
Old Tra ord, M16 9UN, United Kingdom
UNITUNE CLIP
-
1
-
2
