La page est en cours de chargement...
MEGA1 USER MANUAL
I. UPON RECEIPT
Once you have received the unit, please remove it from the packaging and verify that the
following components are also contained within the box:
• Radar unit
• Base
• Rubber grommet
II. ORIENTATION AND INSTALLATION
Before the device can be plugged in, please follow the orientation and installation guide to
place the device at the desired location and angles for usage.
Once the unit is appropriately mounted, supply power via a CAT5/CAT6 cable with a PoE supply;
the supply can be an injector, router, or switch.
III. CONFIGURATION
After the unit is connected, you can further configure and setup the parameters by logging in
with your supplied credentials to www.omnisightusa.com
FCC: 2A6OYMEGA1 IC: 28582-MEGA1
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation)
The license-exempt transmitter / receiver contained in this device complies with the Innovation, Science and Economic
Development Canada NRCs applicable to devices radio exempt from license. Operation is permitted under the following two
conditions: (1) The device may not cause interference; (2) The device must accept any interference radio interference, even if the
interference may compromise its operation.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) L’appareil ne doit pas produire de brouillage; (2) L’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
IV. Regulatory Information
Modifications (FCC 15.21)
Changes or modifications to this equipment not expressly approved by Omnisight, Inc. may void
the user’s authority to operate this equipment.
Radio Frequency Interface (RFI) (FCC 15.105)
This device has been tested and found to comply with the limits for Class B digital devices
pursuant to Part 15 Subpart B, of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential environment. This equipment
generates, uses, and can radiate radio frequency energy, and if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try
and correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RFx warning statement
In order to comply with FCC and ISED RF Exposure requirements, a minimum
separation distance of 200 cm must be maintained between the device and all persons
during normal operation
Afin de se conformer aux exigences d'exposition RF FCC et ISED, un minimum
une distance de séparation de 200 cm doit être maintenue entre l'appareil et toutes les
personnes pendant le fonctionnement normal
Suppliers Declaration of Conformity
47 CFR 2.1077 Compliance Information
Unique Identifier: 2A6OY-MEGA1
Responsible Party – U.S. Contact Information
Omnisight, Inc
295 Seven Farms Drive
Suite C-289
Daniel Island, SC 29492
Website: www.omnisightusa.com
Contact Email: [email protected]
/
