Prime-Line H 3934 Mode d'emploi

Marque
Prime-Line
Modèle
H 3934
Taper
Mode d'emploi
H-3934
NOTE: Installation drawings are typical for this style of replacement part.
They may not show a part identical to the one you are installing.
NOTA: Los dibujos para la instalación son genéricos para repuestos de
este tipo; por lo que podrían no mostrar una pieza idéntica a la que usted
esté instalando.
REMARQUE : Les dessins d'installation sont typiques pour ce style de
pièce de rechange. Ils pourraient ne pas illustrer une pièce identique à
celle que vous installez.
H-3934-INS
26950 San Bernardino Ave., Redlands, CA 92374
© 2010 Prime-Line Products
Jalousie window security clip
Ventana de Jalousie: Clip de seguridad
Agrafe de sécurité de fenêtre de jalousie
Figure A
Figure B
Figure C
Clip
Upper
Leg
Bracket
Lower Leg
Upper Leg
Bracket
INSTALLATION HINTS: Open jalousie window and remove the louvre slats (glass, wood or metal)
by sliding towards you. It may be necessary to bend the bracket upper leg down slightly.
Slip security clips over both ends of slat(Fig. A). Use pliers to gently conform clip to the size and
shape of the slat (Fig. B). Use
caution
when crimping over glass slats, as breakage can occur.
Open bracket lower leg to allow 5/16" clearance. Re-install louvre slat, with security clip attached,
into the appropriate retainer brackets. Note: Lift back leg of security clip and allow to straddle the
bracket upper leg (Fig. C). Attach retainer clip as shown. Bottom leg of clip slips between louvre
slat and brakcet. Top leg of clip (with flared lip) slips over security clip, just above the locking detent.
Lower Leg
4"
10 cm
3/8"
10 mm
• Fits 4" louvre slats
• Prevents removal of louvre
slats from outside
• Stainless steel
  • Page 1 1

Prime-Line H 3934 Mode d'emploi

Marque
Prime-Line
Modèle
H 3934
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents