EYE Lighting International of North America, Inc.
A division of Iwasaki Electric of Japan
Page 2 of 2
9150 Hendricks Road Tel: (888)665-2677 EQS3763 REV:4 06/03/2016
Mentor, Ohio 44060 Fax (440) 350-7001 www.eyelighting.com
APPLICATION
This medium-size square-profile floodlight combines the
durable strength of die-cast body construction with an
aesthetically pleasing shape. It is fully sealed and gasketed for
both upward and downward aiming. Its faceted reflector
assembly delivers an effective forward throw pattern. This
fixture is fitted for several mounting arrangements. It
includes a water-tight bushing and cord, so it is ready for use
in wet locations. Typical applications include general lighting
of grounds, storage yards, auto sales lots, parking areas, and
floodlighting of signs and building fronts.
INSTALLATION YOKE MOUNT:
Drill holes in the mounting surface and bolt the
trunnion/yoke in place. Attach the floodlight to the
trunnion/yoke with the two bolts provided. If using the
provided watertight cord and bushing: Route the cord into a
nearby junction box and splice the wires to the branch circuit
wires, black to black (hot), green to green (ground), and white
to white (neutral). Ensure that the entry hole to the junction
box is made watertight with a bushing or other device. If
using electrical conduit: Open the fixture wiring compartment
by loosening the two tamper-proof screws. Remove the
watertight cord and bushing from the hole at the base of the
fixture. Attach the conduit and route the branch circuit wires
inside the fixture wiring compartment. Splice the fixture wires
to the branch circuit wires, black to black (hot), green to
green (ground), and white to white (neutral). Close the
wiring compartment by screwing down the two tamper-proof
screws.
SLIP FITTER:
Remove the watertight bushing from the floodlight. Pull the
floodlight wires through the slip fitter and attach the slip
fitter to the floodlight using the provided bolts. Splice the
branch circuit wires to the floodlight wires: black to black
(hot), green to green (ground), and white to white (neutral).
Push the splices inside the pole. Slide the slip fitter over the
top of the pole and tighten the set screws to hold the
floodlight in place.
DRIVER VOLTAGE
The driver installed in this fixture is designed for operating
voltages in the range 120 to 277 volts AC. High voltage
fixture model options for 347/480V systems are available via
integral step down transformers.
ACCESSORIES
A photocell option is available.
TROUBLE-SHOOTING CHECKLIST:
If the luminaire does not function
Check your power source.
Check the electrical connections.
DÉPANNAGE CHECKLIST:
Si le luminaire ne fonctionne pas.
Vérifiez votre source d'alimentation.
Vérifiez les connexions électriques
Do not install damaged luminaire equipment. Contact EYE Lighting, and return for inspection and repair.
Modifications to the device or changes of its design are not permitted.
The equipment must be operated according to the intended purpose in an undamaged condition.
Ne pas installer de l'équipement de luminaire endommagé . Contactez- EYE Lighting, et retourner pour inspection et réparation .
Les modifications apportées à l'appareil ou des modifications de sa conception ne sont pas autorisés .
L'équipement doit être utilisé selon l' usage prévu dans un état intact .
EYE Lighting is not responsible for claims arising from improper or careless installation or handling of luminaires.
EYE Lighting est pas responsable des réclamations découlant d'une mauvaise installation ou négligente ou de manutention des
luminaires.
**Retain a copy of these instructions**
**Conservez une copie de ces instructions**