$.5
$.0$.%
1.
Control panel.
2.
Grease filters (inside the extractor grille).
3.
Lighting unit.
4.
Pull-out steam deflector.
5.
Fastener for opening and closing grille
(The blue arrows show the direction of opening).
Model AKR 680 is not fitted with its own
extraction unit (motor). It must therefore be
connected to an external extraction unit.
MOUNTING OR RENEWING THE
CARBON FILTER:
Carbon filters cannot be used with model
AKR 680.
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Open the rear extractor grille.
4.
If the carbon filter is already mounted and
needs renewing, turn anticlockwise.
5.
If the filter is not mounted: insert the carbon
filter above the motor protection grille.
Line up the reference mark on the edge of the
carbon filer (
a
) with the arrow on the cowl (
b
).
Then turn clockwise.
6.
Close the rear extractor grille.
RENEWING BULBS
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Open the rear extractor grille.
4.
Remove the burnt-out bulb and insert a new
one. Use 40W max (E14) bulbs only.
5.
Close the rear extractor grille.
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Open the rear extractor grille.
4.
Remove the device fixing the grease filter
and remove the dirty grease filter.
5.
After renewing (for paper grease filters) or
cleaning (for metal grease filters) the grease
filter repeat the above steps in reverse to
reassemble, making sure the entire
extraction surface is covered.
CONTROL PANEL
To switch on the hood, pull
out the steam drawer. To
switch off the hood, close
the steam drawer.
A.
Light switch.
B.
Speed selector (apart
from model AKR 680):
1 = small amount of
steam and fumes.
2 = large amount of
steam and fumes.
MODEL WITH 1 MOTOR:
1 CARBON FILTER
MODEL WITH 2 MOTORS:
2 CARBON FILTERS
1
5
2
4
3
3
5
A
B
a
b
a
a
b
b
PRODUCT DESCRIPTION SHEET
F NL E PGBD GRI