Whirlpool AKR 634 BR Program Chart

AKR 634 BR
Whirlpool
Marque
Whirlpool
Modèle
AKR 634 BR
Taper
Program Chart

Ce manuel convient également à

5019 100 75034
AKR 634
INSTALLATIONSANGABEN
Mindestabstand zur Kochfläche: 43 cm (Elektroplatten), 65 cm (Gas-, Öl- oder
Kohlekochplatten)
INSTALLATION SHEET
Minimum height above cooker: 43 cm (electric cookers), 65 cm (gas, gas oil or coal cookers)
FICHE D'INSTALLATION
Distance minimale par rapport à la cuisinière: 43 cm (cuisinière électrique), 65 cm
(cuisinière à gaz, mazout ou charbon)
INSTALLATIESCHEMA
Min. afstand van het kooktoestel: 43 cm (elektrische kooktoestellen), 65 cm
(kooktoestellen op gas, olie of kolen)
FICHA DE INSTALACIÓN
Distancia mínima desde los quemadores: 43 cm (quemadores eléctricos), 65 cm
(quemadores a gas, gasóleo o carbón)
FICHA DE INSTALAÇÃO
Distância mínima do fogão: 43 cm (fogões eléctricos), 65 cm (fogões a gás, óleo ou carbono)
SCHEDA INSTALLAZIONE
Distanza minima dai fuochi: 43 cm (fuochi elettrici), 65 cm (fuochi a gas, gasolio o carbone)
ù(ùü+ù$ùþ
ü$12.)12.1.)2"0120" FP02!"0120" FP0120".0! #
02!0. #0! #.
D
GB
F
NL
E
P
I
*5
1
3
2
AKR 634
5019 100 75034
AA
A
FF
F
4
6
Ø
135mm
8
7
9
10x10mm
5
16
12
11
13
20mm
16mm
OK!OK!
OK!
10
14
15
AKR 634
5019 100 75034
1.
Control panel.
2.
Grease filters (inside the extractor grille).
3.
Lighting unit.
4.
Pull-out steam deflector.
RENEWING THE NEON LIGHT BULB
1.
Unplug the appliance or switch off the mains
power supply.
2.
Open the lighting unit.
3.
Remove the burnt-out neon bulb and insert a
new one (turn anticlockwise and unhook from
the two lamp-holders on the end of the neon
itself). Use 14Watt (max) neon bulbs only.
The starter can be found on one end of the
neon behind one of the lamp-holders. If the
neon still does not light up, replace the starter
(bayonet fitting) with a new starter for 14 Watt
(max) bulbs.
4.
Close the lighting unit.
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Remove the extractor grille.
4.
Release the grease filter.
5.
Remove the dirty grease filter.
6.
After renewing or cleaning the grease filter
(depending on model - see the “Instructions”
manual provided with this sheet) repeat the
above steps in reverse to reassemble,
making sure the entire extraction surface is
covered.
MOUNTING OR RENEWING THE
CARBON FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Remove the extractor grille.
4.
If a carbon filter is already mounted and
needs renewing, press the release buttons
(
b
) and pull the filter out downwards.
5.
If the filters are not mounted:
a.
fit the carbon filter into the upper clips.
b.
fasten using the lower clips.
6.
Remount the extractor grille.
CONTROL PANEL
A.
Light switch.
B.
Speed selector.
C.
Intensive extraction.
2
3
4
1
O
O
large amount of
steam and fumes
medium amount of steam and fume
s
BA
small amount of steam and fumes
C
PRODUCT DESCRIPTION SHEET
F NL E PGBD GRI
  • Page 1 1
  • Page 2 2
  • Page 3 3

Whirlpool AKR 634 BR Program Chart

AKR 634 BR
Whirlpool
Marque
Whirlpool
Modèle
AKR 634 BR
Taper
Program Chart
Ce manuel convient également à
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents