5019 607 00186
1. Check that all fastenings are closed and that
pockets are empty.
2. Turn the articles inside out.
3. Place laundry loosely in the drum to make sure
it doesn’t become tangled.
Sort laundry as follows:
A) By care symbols
(on the collar or inside seam):
Suitable for tumble drying
Tumble drying with reduced drying intensity
only
Do not tumble dry
B) By amount and thickness/weight
Whenever the load to be dried exceeds dryer
capacity, separate laundry according to weight
(e.g. towels from thin underwear).
C) By type of fabrics
Cotton/linen
: Towels, cotton jersey, bed and
table linen made of cotton or linen.
Synthetics/Easy Care
: Blouses, shirts, overalls,
etc. made of polyester or polyamide, as well as
cotton/synthetic mixes.
D) By drying level
• Sort into: iron dry, cupboard dry, etc.
Do not tumble dry:
Woollens, silk, nylon
stockings, delicate embroidery, fabrics with metallic
decorations, bulky items such as sleeping bags, etc.
Important: only use specific indicated dryer-safe
additives
and rinse items that have been treated
with stain remover thoroughly in plenty of water
before drying.
Only use specific indicated dryer-
safe plastic items
and never dry rubber or articles
contaminated with vegetable oil in the dryer
Programmes and Options:
• To select a programme, turn the programme
selector knob.
• To select an option (if available), press the
corresponding button before pressing the Start
button. The light above the button confirms that
a selection has been made. An alarm sounds if an
incorrect selection is made (incompatible
options).
• Press the button again to cancel the option.
1. Having selected the desired programme and
options, press the Start button.
If the laundry is not removed at the end of the
drying cycle, an automatic anti-crease cycle will
operate for maximum 70 min. The drum rotates
at regular intervals, preventing the laundry from
creasing.
2. On completion of the programme, set the
programme selector knob to position “0”.
The dryer indicator lamp “On” switches off.
When changing the programme during the drying
cycle, the dryer stops.
To operate the new programme, press the start
button again.
To interrupt the dryer during operation
1. Set the programme selector knob to “Airing”.
2. Press the Start button.
Wait at least 5 minutes before opening the
door to allow the dryer to cool down.
For your safety the programme stops
automatically if you open the door.
3. To restart, after door opening, close the door
and press the start button again.
Clean the lint filter at the end of every drying
cycle:
1. Open the door.
2. Pull the filter upwards.
3. Remove lint using a soft brush or your fingertips.
4. Push the filter firmly back into place.
To built in the dryer
1. It is recommended to not remove the work-top.
2. Connect the dryer to an external ventilation
system in order to prevent steam from
damaging your furniture during the years.
If a fault occurs, before contacting our After-
Sales Service, make the following checks to try
and remedy the problem:
Drying takes too long / laundry is not dry enough:
• Was the correct programme selected?
• Was the inserted laundry too wet (Washing
machine spin speed less than 800 rpm)?
• Is the lint filter dirty (filter indicator lamp on)?
The dryer does not operate:
(following a power failure and/or interruption
to the mains supply, always press the Start
button).
• Is the power plug properly inserted into the
mains electricity socket?
• Is there a power failure?
• Has the fuse blown?
• Is the door properly closed?
• Has the programme been selected?
• Has the
Start
button been pressed?
Lint filter indicator lamp on:
• Is the lint filter clean?
• Is the vent hose blocked?
If, after carrying out the above checks the
malfunction persists or appears again, turn the
dryer off and call our After-Sales Service (refer
to guarantee).
Please specify:
• the nature of the fault.
• the dryer type and model.
• the service code (the number after the word
Service on the adhesive rating plate) on the right
hand side when the door is open.
• your full address and phone number.
PREPARING THE LAUNDRY SELECTING A PROGRAMME AND
OPTIONS
STARTING AND COMPLETING A
PROGRAMME
CHANGING A PROGRAMME
INTERRUPTING A PROGRAMME
FILTER
BUILT-IN INSTALLATION
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE