DNI 3260, DNO 3260,
DNO 620 EV
5019 100 75031
1.
Control panel.
2.
Grease filters (inside the extractor grille).
3.
Lighting unit.
4.
Pull-out steam deflector.
5.
Fastener for opening and closing grille
(The blue arrows show the direction of
opening).
Model DNO 3260 EV is not fitted with its own
extraction unit (motor). It must therefore be
connected to an external extraction unit. This
has a solenoid valve which on opening (to
open the valve, pull out the steam deflector)
allows flow-through of the extracted air.
Model DNO 3260 is the same apart from the
solenoid valve.
RENEWING BULBS
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Open the rear extractor grille.
4.
Remove the burnt-out bulb and insert a new
one.
Use 40W max (E14) bulbs only.
5.
Close the rear extractor grille.
CLEANING THE GREASE FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Open the rear extractor grille.
4.
Remove the grease filter fixing device.
5.
Remove the dirty grease filter.
6.
After cleaning the grease filter repeat the
above steps in reverse, making sure the
entire extraction surface is covered.
CONTROL PANEL
To switch on the hood,
extract the steam deflector.
To switch off the hood,
close the steam deflector.
A.
Light switch.
B.
Speed selector (only for
model DNI 3260)
1 =small amount of
steam and fumes
2 =large amount of
steam and fumes
ONLY FOR MODEL DNI 3260
MOUNTING OR RENEWING THE CARBON FILTER:
1.
Unplug the appliance or switch off the mains power supply.
2.
Pull out the steam deflector.
3.
Open the rear extractor grille.
4.
If the carbon filter is already mounted and needs renewing, turn clockwise.
5.
If the filter is not mounted: insert the carbon filter above the motor protection grille. Line up the
reference mark on the edge of the carbon filter (
a
) with the arrow on the cowl (
b
). Then turn
clockwise.
6.
Close the rear extractor grille.
1
5
2
4
3
3
5
A
B
a
b
F NL E PGBD GRI
PRODUCT
DESCRIPTION SHEET