Extron HD 4K 101 Plus Manuel utilisateur

Catégorie
Séparateurs vidéo
Taper
Manuel utilisateur
IMPORTANT:
Go to www.extron.com for the
complete user guide and installation
instructions before connecting the
product to the power source.
HD4K101Plus • Setup Guide
Overview
The Extron HD4K101Plus is a cable equalizer that actively conditions incoming HDMI signals to compensate for signal loss when long
HDMI cables, low quality HDMI cables, or source devices with poor HDMI signal output are used. It extends Ultra High Denition (UHD)
and 4K signals up to 50feet (15meters).
Front Panel
A
Power and signal status LED — This LED lights amber when the unit is
receiving power from the HDMI source or an external power supply. It lights
green when there is an active HDMI signal.
B
HDMI input — Connect the source device to this input.
HD 4K 101 Plus
HDMI IN
A
B
Rear Panel
A
Power input — Connect the (optional) 12VDC, 0.5A power supply to this
power input.
Alternatively, the HD4K101Plus can draw power from the source device
over the HDMI cable but this reduces the maximum cable length (see
Maximum Cable Distances on page2).
B
HDMI output — Connect the display to this output. This cable should be a
maximum of 15 feet (5 meters).
POWER
12V
0.2A MAX
HDMI OUT
A
B
Installation
1. Mount the HD4K101Plus in a suitable location. The unit should
be at the end of a long cable run from the source device and close
to the output device.
The unit can be placed on a table top or, with the appropriate kit,
mounted on a rack, or mounted under or through furniture. Follow
the instructions provided with the kit.
2. Connect the source device to the input of the equalizer (see
Maximum Cable Distances for the maximum cable distances).
3. Connect the display device to the output of the equalizer. This
cable should be a maximum of 15feet (5meters).
NOTE: Use the provided LockIt™ HDMI lacing brackets to
secure the HDMI connectors (see the HD4K101Plus User
Guide at www.extron.com).
4. If required, connect a power supply (optional) to the 2-pole
captive screw connector.
ATTENTION:
Do not power on the input and output devices until you
have read the Attention in the Power Supply section of the
HD4K101Plus User Guide.
Ne branchez pas les appareils d’entrée et de sortie avant
d’avoir lu la mise en garde dans la section «sources
d’alimentation» du Guide de l’utilisateur HD4K101Plus.
HDMI IN
HDMI OUT
HD 4K 101 Plus
POWER
12V
--A MAX
MODEL 80
PC
4K/60Hz Output
4K Display
Extron
HD 4K 101 Plus
HDMI Cable Equalizer
for Ultra HD
and 4K Sources
Extron
HDMI Pro Series Cable
Short HDMI
Cable
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the Extron Safety and
Regulatory Compliance Guide on the Extron website.
© 2016-2020 Extron Electronics — All rights reserved. www.extron.com
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
Maximum Cable Distances
The maximum cable distance depends on resolution, frequency, and, for PC resolutions, the power of the graphics card (when powered
by the source). When the source is a PC, Extron recommends the HD4K101Plus be powered by an external power supply.
Resolution Refresh (Hz) Maximum Distance Resolution Refresh (Hz) Maximum Distance
720p 60 150 feet (45.7 meters) 3840x2160 (UHD) 24/30 75 feet (22.9 meters)
1080i 30/60 150 feet (45.7 meters) 4096x2160 (4K) 24/30 75 feet (22.9 meters)
1080p 24/30 150 feet (45.7 meters) 3840x2160 (UHD) 60 50 feet (15.2 meters)
1080p (8 bit or deep color) 60 125 feet (38.1 meters) 4096x2160 (4K) 60 35 feet (10.7 meters)
For additional resolutions refer to the HD4K101Plus User Guide (available at www.extron.com) or the product label.
Internal Settings
ATTENTION:
Use electrostatic discharge (ESD) precautions (be electrically grounded) when making connections.
Prenez des précautions contre les décharges électrostatiques (soyez électriquement relié à la terre) lorsque vous effectuez des
connexions.
Under most conditions, the HD4K101Plus works without adjustments. However, the quality of the image displayed may be affected by
a combination of the source, display, and cable length. If so, use the two sets of internal jumper switches to adjust Equalization (EQ), and
Pre-emphasis.
1. Remove the cover of the unit, as described in the HD4K101Plus User Guide.
2. Position the HD4K101Plus with the front panel (status LED) furthest from you and the rear panel (power input) closest to you. In
that orientation, the Pre-emphasis jumpers are furthest from you and the EQ jumpers are closest to you.
3. Set the jumper switches as shown in the table below and replace the cover to the unit.
Jumper Function Jumper
Pins 2 and 3
Jumper
Pins 1 and 2
No
Jumper
J3
(DDC CLK Buffer)
J4
(DDC DATA Buffer)
Some applications require that the DDC be buffered for proper
operation.
Adjusting this jumper can clean up the signal to allow it to extend
further.
NOTE: Jumpers J3 and J4 must be configured together,
either both on or both off.
Off
1
3
1
3
On
Default
NA
J5 (EQ)
Adjusting this jumper can improve the image for some applications
with longer cable runs, image artifacts, or both.
Setting for J5 (EQ), based on resolutions and the input HDMI cable
lengths used:
High:
1080p @ 60 Hz with input cables 100-125 feet.
4k/30 with input cables 50-75 feet.
4k/60 with input cables 25-35 feet.
Mid:
1080p @ 60 Hz with input cables 50-100 feet.
4k/30 with input cables 25-50 feet.
4k/60 with input cables 15-25 feet.
Low:
1080p @ 60 Hz with input cables 15-50 feet.
4k/30 with input cables 15-25 feet.
4k/60 with input cables less than 15 feet.
Low
1
3
Mid
1
3
High
Default
1
3
J6
(Pre-emphasis)
Adjusting this jumper can compensate for signal degradation in
applications with higher data rate, higher resolution, or both. This
adjustment is recommended for resolutions of 2560x1600@60Hz
or higher.
On
1
3
Off
Default
1
3
Not used
1
3
68-2892-50 Rev. C
06 20
  • Page 1 1
  • Page 2 2

Extron HD 4K 101 Plus Manuel utilisateur

Catégorie
Séparateurs vidéo
Taper
Manuel utilisateur

dans d''autres langues