EMERGE COPIER GUARDIAN I I Mode d'emploi

Marque
EMERGE
Modèle
COPIER GUARDIAN I I
Taper
Mode d'emploi
USER'S GUIDE
USER'S GUIDE
Thank you for purchasing this Copier Guardian II. Smart Power
Systems is dedicated to developing and manufacturing the highest
performance power protection and filtration devices for your
electronic equipment. Proper use of this device will provide the
protection needed for your connected equipment.
COPIER G UARDIAN I I
COPIER G UARDIAN I I
WITH SMART
GROUND
P.N.16004540 Rev.06/22
ELECTRONIC POWER CONDITIONER
TRAN S F O RMER
BASE D F I LT E R
Use this user's guide for the following products:
MODEL / PART NUMBER
DESCRIPTION
120V/15A, two 5-15R outlets
120V/15A, ONE 5-15R pigtail outlet, RJ11+RJ45
120V/15A, two 5-15R outlets , RJ11+RJ45
120V/15A, two 5-15R outlets and one 5-15R pigtail outlet, RJ11+RJ45
120V/20A, one 5-20R pigtail outlet
120V/20A, one 5-20R pigtail outlet, RJ11+RJ45
120V/20A, one 5-15R outlet, one 5-20R pigtail outlet, RJ11+RJ45
ZERO CROSS PROTECTION, 120V/15A, two 5-15R outlets, RJ11+RJ45
ZERO CROSS PROTECTION, 120V/20A, one 5-20R outlet, RJ11+RJ45
208V - 240V/15A, one 6-15R pigtail outlet, RJ11+RJ45
208V - 240V/20A, one 6-20R pigtail outlet, RJ11+RJ45
TBF15C-1120
TBF15C-1111TN
TBF15C-1121TN
TBF15C-1131TN
TBF20C-1210
TBF20C-1211TN
TBF20C-1221TN
TBF15CZ-1121TN
TBF20CZ-1211TN
TBF15C-2111TN
TBF20C-2211TN
Modem & Data Protection (model dependent)
Protection is extended to your phone and network lines with the addition of RJ11 and RJ45 jacks
on the Copier Guardian II unit, creating ideal protection for Fax/Internet/Network users. Power
surges can pass to a copier through phones lines and network cables.
CAUTION
CAUTION
CAUTION
CAUTION
• Use only in dry locations indoors.
• Avoid dropping the unit.
• Only plug the Copier Guardian II into a three pronged grounded outlet. This unit is not to be
used with any type of ground “lift” or pin eliminator.
• Do not open the Copier Guardian II unit, there are no serviceable parts inside. Opening the unit
will void your warranty.
This device features an internal protection that will disconnect the surge protective component
at the end of its useful life but will maintain power to the load now unprotected. If this situation
is undesirable for the application, follow the manufacturer's instructions for replacing the device.
Do not install this device if there is not at least 10 meters (30 feet) or more of wire between the
electrical outlet and the electrical service panel.
Risk of Electric Shock. Do not plug into another relocatable power tap.
FEATURES
If you have any questions call us at our Tech Support line toll free
1-800-772-7633 or email us at [email protected]
•• Utiliser uniquement dans des endroits secs à l'intérieur.
• Évitez de faire tomber l'appareil.
• Brancher le Copier Guardian II en trois volets prise de terre. Cette unité ne doit pas être utilisé
avec tout type de terrain "ascenseur" ou broches éliminateur.
• Ne pas ouvrir l'unité Copier Guardian II, il n'y a pas de pièces réparables. Ouverture de l'unité
annulera votre garantie.
Cet appareil dispose d'une protection interne qui va déconnecter le composant de protection contre
les surtensions à la fin de sa vie utile mais se maintenir au pouvoir à la charge maintenant sans
protection. Si cette situation est souhaitable pour l'application, suivez les instructions du fabricant
pour le remplacement de l'appareil.
Ne pas installer cet appareil si il n'y a pas au moins 10 mètres (30 pieds) ou plus de fil entre la prise
électrique et le panneau de service électrique.
ATTENTION
ATTENTION
ATTENTION
ATTENTION
Risque de choc électrique. Ne branchez pas dans une autre puissance robinet délocalisables.
1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the Copier Guardian II Unit.
3. Plug the Copier Guardian II unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the Copier Guardian II where monitoring lights can
be observed.
INSTALLATION OF TBF™
Use the Standard CAT 5 Network Patch cord when using the Network protection RJ45 circuit.
Connected
Equipment with
Tel./Modem Jack
Power Cord
Power Cord
Pigtail
Outlet
Copier Guardian
Power Cord
Phone Cord
Phone Cord
Network Cord
Network Cord
LINE
LINE
DEVICE
DEVICE
Phone
Wall Jack
Network Jack/ HUB
Connected
Equipment with
Network Jack
Installation for Protection for Telephone Line and Network Cable
TELEPHONE
1. Unplug the equipment's telephone cable from the wall jack and plug into the RJ11 "DEVICE" on
the Copier Guardian II.
2. Plug the provided telephone cable to the RJ11 jack "LINE" on the Copier Guardian II.
3. Plug the other end of the telephone cable into the RJ11 wall jack.
Telephone Line Protection clamping voltage 250-350 vdc.
NETWORK
1. Unplug the equipment's network cable from the wall RJ45 network jack and plug into the RJ45
"DEVICE" on the Copier Guardian II.
2. Plug the provided network cable to the RJ45 jack "LINE" on the Copier Guardian II.
3. Plug the other end of the network cable into the wall RJ45 network jack. Your equipment is now
fully protected. Place the Copier Guardian II where monitoring lights can be observed.
NOTE: All Copier Guardian II
units come with security straps,
warning label to secure unit to
connected equipment.
STRAP FOR PIGTAIL
RECEPTACLE
SECURITY STRAP WITH
WARNING LABEL
CAUTION: - Never install telephone wiring during a lightning storm.
- Disconnect telephone line at the network interface before installing the secondary
protector.
- Intended for indoor use only.
The GREEN light confirms properly the connected equipment is fully protected. The RED light
indicates over voltage, improper ground connection or reversed power wires which needs to
be corrected. In an over voltage incident, power is disconnected to protect the connected
equipment. IMPORTANT: If the RED Light comes on, contact your electrician to inspect
and correct the outlet wiring in order to receive the maximum protection for your connected
equipment.
CONNECTED
EQUIPMENT
7409 Railhead Ln. - Houston, Texas 77086 - Tel:(713)464-8000 - Fax:(713)984-0841
E-mail: [email protected] - www.smartpowersystems.com
TRANSFORMER BASED FILTER (TBF™) SERIES
Considered to be one of the most significant developments in the power protection industry. TBF™
Filters contain innovative technology that combines Surge Suppression and Noise Isolation which
filters the noise on the ground to less than 0.5 Volts (US Patent # 6229682). Exclusive "POVP"
Prolonged Over Voltage Protector (US Patent # 6560086) disconnects the output power if voltage
exceeds 155 volts. Exclusive Smart Technology (US Patent #5721661) protects microprocessor
based equipment against reverse polarity or no ground. The patented TBF™ filters prevent 90% of
the power problems experienced by your POS system, computer, copier and facsimile machine.
UL 1449 3rd. Edition Listed
IMPORTANT
If for any reason you need to return the Copier Guardian II unit to the manufacturer, you
should obtain an RMA (Return Material Authorization) number before returning the unit.
To request an RMA number please call 1-800-772-7633 or visit the website at
https://www.smartpowersystems.com/main/rma.htm
WARRANTY
Limited Lifetime Warranty
If the Smart Power Systems equipment fails and this failure allows a surge to pass through and
damage the connected equipment, Smart Power Systems will pay for the repair or replacement of
the connected equipment of the original purchaser. Please take the time to register each Smart
Power Systems' product along with the connected equipment devices connected to it within 10
days of date of purchase in order for you to take advantage of this product warranty and connected
equipment protection policy. See our website for more details - www.smartpowersystems.com
$25,000 Connected Equipment Warranty
Smart Power Systems warrants to the original purchaser that the power conditioners shall be free of
defects in material and workmanship under normal use and service for the lifetime of the original,
registered connected equipment, and Smart Power Systems will repair or replace, at its sole option,
any defective power conditioners free of charge. This warranty is not transferable. See our website
for more details - www.smartpowersystems.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

EMERGE COPIER GUARDIAN I I Mode d'emploi

Marque
EMERGE
Modèle
COPIER GUARDIAN I I
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Autres documents