Sunsa 1 Sunsa Wand Mode d'emploi

Taper
Mode d'emploi

Ce manuel convient également à

QUICK START GUIDE
IN THE BOX
Sunsa Wand
Sunsa Wand Tips
Sunsa Wand Adapters
X1
X3
X3
AA Batteries
Quick Start Guide
X4
X1
Sunsa Wand Tips
CONTACT US
www.sunsahomes.com
contact@sunsahones.com
443-692-7267
SETUP
1. Download the Sunsa
app and create an account
2. Follow the Sunsa app to finish setup
Sunsa Wand Adapters
FCC ID : 2AYPZ-SUNSAW1
IC :26999-SUNSAW1
Warning Statement
This device complies with part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device meets the FCC requirements for RF exposure in public or uncontrolled environments for
extremity exposure conditions.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
  • Page 1 1
  • Page 2 2

Sunsa 1 Sunsa Wand Mode d'emploi

Taper
Mode d'emploi
Ce manuel convient également à

dans d''autres langues