13
en
SAVE SETTINGS
The BONECO U350 saves the last-used settings when it
is switched off. However, if the appliance is disconnected
from the power supply for a few seconds, it will start in
the operating mode.
“AUTO” COMFORT MODE
In mode the humidification is controlled automa-
tically and the humidity is set to 50%. As soon as the
humidity or the ultrasonic is manually adjusted, however,
the appliance leaves mode.
To return to mode, tap the symbol once.
The heater can be switched on or off without the ap-
pliance leaving mode. mode also remains
active when setting the timer.
CONTROLLING HUMIDITY
The humidity can be set between 30% and 70%. In the
“Co” setting (for “Continuous”), the ultrasonic runs re-
gardless of the measured humidity. This means it does
not switch off until the tank is empty or the appliance is
switched off.
1. Tap the symbol. The current humidity indicator
starts flashing.
2. While the indicator is flashing, tap the symbol again
until the desired humidity is set.
The value is applied after a few seconds. The indicator
stops flashing.
REGULATING PERFORMANCE
1. Tap the symbol multiple times until the desired le-
vel appears on the display.
The symbol on the display indicates which of the three
levels (low/medium/high) has been selected:
HUMIDITY AND ULTRASONIC